Abstract:Controlling the interfacial interaction is a prerequisite for the preparation of aluminum matrix composites reinforced by carbon nanotubes (CNTs) with high performance. In this paper, Cu-coated CNTs fabricated by the compound reduction method were applied to control the interfacial interaction between carbon nanotubes and aluminum matrix for improving the interfacial bonding and mechanical properties of aluminum matrix composites. The microstructure, interfacial structure, interfacial interaction, and mechanical properties of Cu-coated composite were studied in detail. The in-depth study results show that Cu nanoparticles act as a bridge connecting the carbon nanotubes and matrix and forming Al2Cu intermetallic, which is in favour for better dispersion of carbon nanotubes and interfacial bonding. In addition, Cu nanoparticles are preferentially deposited at the defects of carbon nanotubes to repair the defects and inhibit the formation of brittle Al4C3 phases. As a result, Cu-coated composite displays the superior strength with yield strength and ultimate tensile strength of 203 MPa and 287 MPa, which are 45% and 38% higher than those of matrix (140 MPa and 207 MPa) and 8% and 12% higher than those of uncoated composite (188 MPa and 256 MPa), respectively. The introduction of Cu nanoparticles can significantly improve the interfacial bonding strength of Cu-coated composite, ensuring the effective transfer of load from the matrix to carbon nanotubes and exerting its strengthening and toughening effect.

Analysis of Load Transfer Mechanism in Cu Reinforced with Carbon Nanotubes Fabricated by Powder Metallurgy Route

Microstructures and Tensile Behavior of Carbon Nanotubes Reinforced Cu Matrix Composites with Molecular-Level Dispersion

Mechanical Properties of Cu-Based Composites Reinforced by Carbon Nanotubes

Effects of carbon nanotube reinforcement and grain size refinement mechanical properties and wear behaviors of carbon nanotube/copper composites

Effect of Carbon Nanotubes as Reinforcement on the Mechanical Properties of Aluminum-Copper-Magnesium Alloy

Microstructure and Mechanical Properties of Cu-CoatedCarbon-Nanotubes-Reinforced Aluminum Matrix Composites Fabricated by Ultrasonic-Assisted Casting

Influences of Carbon Nanotubes on Performance of W-Cu Composite Materials

Mechanical and Conductive Properties of Cu Matrix Composites Reinforced by Oriented Carbon Nanotubes with Different Coatings

Enhancement mechanisms of mechanical, electrical and thermal properties of carbon nanotube-copper composites: A review

Study on the Mechanism of CNTs Regulating the Microstructures and Properties of Al–Cu–Mg Alloy

Tribological properties of carbon-nanotube-reinforced copper composites

Distribution and Integrity of Carbon Nanotubes in Carbon Nanotube/Magnesium Composites

Preparation, microstructure and properties of Cu-8.3Al/CNTs composites with different volume fractions of CNTs

Improvement of interfacial interaction and mechanical properties in aluminum matrix composites reinforced with Cu-coated carbon nanotubes

Microstructure and Strengthening Mechanism of Carbon Nanotubes Reinforced Magnesium Matrix Composite

A comparison study of the strengthening effect of carbon nanomaterial reinforcements in the 3D skeleton-reinforced copper matrix composites

Achieving good strength‐plasticity compatibility in Cu composites via carbon nanotube (CNT)‐induced heterogeneous bimodal structure

Fabrication of Carbon Nanotube Reinforced Al Composites with Well-Balanced Strength and Ductility

Fabrication and Mechanical Properties of CNT/Al Composites Via Shift-Speed Ball Milling and Hot-Rolling

Effects of the addition of CNTs and Al alloying on the microstructure and properties of Cu-(Al)/CNTs composites