Abstract:This paper presents the analytical methods of slope-stabilising piles using the three-dimensional (3-D) finite element (FE) analysis with the strength reduction method (SRM). This 3-D FE model is employed to overcome the limitations observed in two-dimensional (2-D) FE analysis. The solutions obtained from 3-D FE analyses are verified to be less conservative in this paper. The 3-D analysis is considered to be of particular importance to pile-slope problems. The soil that flows between piles cannot be taken account properly in the 2-D FE analysis. The method adopted in this paper can avoid the assumption of soil movement and the pressure distribution along the piles subjected to soil movement. The numerical analysis employs the Mohr–Coulomb failure criterion with the strength reduction technique for soil and an elastic member for piles. The spacing effect of the pile is considered in the 3-D model, the S/D (S: centre to centre, D: diameter of pile) ratio, equal to 4.0, is found to be equivalent to the single pile stabilisation. The middle portion of the slope is identified as the optimal location to place the piles. The proper length of the pile, which can be used to stabilise the slope, is also examined using 3-D FE analyses. It is concluded that L/H greater or equal 0.70 is recommended (L: pile length, H: slope height). The numerical analyses are conducted based on a coupled analysis, which simultaneously considers both the slope stability and the pile response. The failure mechanisms of the pile-slope system subjected to the pile locations, pile head conditions and pile length are each discussed. The contact pressure, shear force and moment along the piles are presented to illustrate the pile stabilising mechanism herein.

Experimental and Numerical Study of Pile-Stabilized Slopes Under Surface Load Conditions

Large Deformation Analysis of Intermittent Pile Penetration into Dense Sand Incorporating a State Dependent Mohr–Coulomb Model

Advanced laboratory investigation of axial cyclic loading in silica sands

A Robust and Efficient Method of Designing Piles for Landslide Stabilization

Centrifuge Model Tests on Laterally Loaded Piles in Sand

Soil-pile interaction on an instrumented pile under cyclic axial loads in sand

Effect of Loading Rate on Lateral Pile-Soil Interaction in Sand Considering Partially Drained Condition

A Displacement-Based Method for Evaluating the Stability of a Pile-Stabilized Slope

Analytical assessment of dynamic stability in 2D unsaturated soil slopes reinforced with piles

Assessment of Cohesive Soil Landslide Driving Forces Exerted on Piles Considering Soil Arching Effects

Analyzing the effectiveness of anti-slide piles for slope stabilization against seismic loading using discrete element method

Numerical analysis of pile reinforcement effect on cohesive and cohesionless soil slopes for assisting remote sensing

Stability Analysis of Strain-softening Slope Reinforced with Stabilizing Piles

Simplified Evaluation on the Stability Level of Pile-Reinforced Slopes

Model Test and Numerical Simulation of Single Pile Response under Combined Loading in Slope

Pile Reinforcement Mechanism of Soil Slopes

Numerical study on lateral response of piles in sandy slopes employing a hardening soil model

Behavior of Soil Slopes Reinforced with Composite-Structural Piles

Pile-Reinforcement Behavior of Cohesive Soil Slopes: Numerical Modeling and Centrifuge Testing

Three-dimensional finite element analysis for soil slopes stabilisation using piles

Progressive Failure Behavior of Pile-Reinforced Clay Slopes under Surface Load Conditions