Effect of the Post-Deposition Thermal Treatment on the Mechanical Properties of a Compositionally Modulated CrAlSiN-AlSiN Coating

Lilyana Kolaklieva,Roumen Kakanakov,Daniela Kovacheva,Vasiliy Chitanov,Tetyana Cholakova,Christo Bahchedjiev,Stefan Kolchev

DOI: https://doi.org/10.3390/coatings11111311

IF: 3.236

2021-10-28

Coatings

Abstract:A CrAlSiN-AlSiN coating with periodically modulated composition was investigated regarding dependence of the mechanical properties and toughness, morphology, composition, and structure on thermal treatment in the interval of 600–900 °C in argon ambience. The coating exhibited superhardness and high toughness up to 800 °C. A very slight decrease in the nanohardness, resistance to elastic strain to failure, and plastic deformation were observed. The coating had enhanced elastic recovery stable up to 700 °C. It was found that the coating morphology was not substantially influenced by the thermal treatment. X-ray diffraction (XRD) analysis revealed that the modulated coating had a nanocomposite structure, which did not change after annealing, even at 900 °C. The grains were composed mainly of fcc-CrN and h-AlN phases embedded into an amorphous Si3N4 matrix. A small amount of an h-Cr2N phase appeared after heating at temperatures above 700 °C. The coating composition was examined by energy-dispersive X-ray spectroscopy (EDS). The coating was stoichiometric up to 800 °C. It became sub-stoichiometric with respect to nitrogen after annealing at 800 °C and 900 °C. It is thus concluded that the CrAlSiN-AlSiN coating with a periodically modulated structure keeps the combination of superhardness (45.3 GPa) and improved toughness (H3/E*2 = 0.362 GPa, elastic recovery 57%) at temperatures up to 800 °C, and is suitable for high thermal applications.

materials science, multidisciplinary,physics, applied, coatings & films