Abstract:Abstract The corrosion behavior of a high manganese steel in simulated marine splash zone environment was studied by dry-wet cyclic corrosion experiment and electrochemical experiment. Corrosion kinetics, composition, surface morphology, cross-section morphology, element distribution, valence state, polarization curve and electrochemical impedance spectroscopy were analyzed with the aim of characterizing the characteristics of corrosion product films. The results show that in chloride-containing environment, in the initial corrosion products, Mn oxides with porous structure lead to higher corrosion rate. As corrosion extends, the formation of alloy element oxides in corrosion products changes the corrosion properties of rust layers at different stages. Mo oxides form a stable passivation film, which reduces the influence of chloride ion on corrosion. Ni oxides in the inner rust layer facilitate the transformation of goethite, and Cr oxides in the outer rust layer increase the densification of the rust layer. The stability and compactness of Fe 3 O 4 , α -FeOOH and FeCr 2 O 4 in the later corrosion products inhibit the corrosion action of manganese iron oxides and slow down the corrosion rate. With the corrosion durations, the corrosion current density of the sample with the corrosion product film first increases and then decreases, and the corrosion potential first moves negative and then shifts in a positive direction subsequently, indicating that the protective effect of the corrosion product film is gradually significant.

Mechanism of Surface Hole Evolution and Impact on Corrosion Resistance of High-Strength Low-Alloy Weathering Steel

Insight into the Triggering Effect of (al, Mg, Ca, Mn)-oxy-sulfide Inclusions on Localized Corrosion of Weathering Steel

Investigation of Microstructure and Corrosion Behavior of Weathering Steel in Aqueous Solution Containing Different Anions for Simulating Service Environments

Corrosion behavior of the low alloy weathering steels coupled with stainless steel in simulated open atmosphere

Optimizing the corrosion performance of rust layers: role of Al and Mn in lightweight weathering steel

Unlocking the influence of microstructural evolution on hardness and pitting corrosion in duplex stainless welded joints

Corrosion Resistance Performance of Molybdenum-Containing Weathering Steel

Microscopic investigation on pitting corrosion of Ni-Cr-Mo-V high-strength steel weldment in simulated deep-sea environment

Effects of Cu on the corrosion resistance of heat-treated weathering steel in a marine environment

Influence of Ultraviolet Light and Alternating Wet-Dry Environments on the Corrosion Behavior of Weathering Steels

Effects of deoxidation methods on the inclusion characteristics and corrosion behaviour of high-strength low-alloy steels in marine environments

Influence of cementite coarsening on the corrosion resistance of high strength low alloy steel

Corrosion behavior of the high‐strength low alloy steel welded joint in natural seawater

Corrosion Behavior of Low-C Medium-Mn Steel in Simulated Marine Immersion and Splash Zone Environment

Effects of Ti and Cu Addition on Inclusion Modification and Corrosion Behavior in Simulated Coarse-Grained Heat-Affected Zone of Low-Alloy Steels

Mechanical and surface characterization of interstitial‐free steel corroded under wet‐dry salt spray and immersion conditions: A comparative study

Constructing Superhydrophobic WO3@TiO2 Nanoflake Surface Beyond Amorphous Alloy Against Electrochemical Corrosion on Iron Steel

The influence of microstructural evolutions on electrochemical corrosion and passive behavior in precipitation-strengthened high-entropy alloys

The Role of Secondary Phase Precipitates in Zircaloy Corrosion: from Point Defects to Local Percolation

Interaction of erosion and corrosion on high-strength steels used for marine dredging engineering

Corrosion behavior and electrochemical corrosion of a high manganese steel in simulated marine splash zone