Abstract:Seismic isolation technologies for large‐span structures have rapidly developed alongside the popularization of the seismic resilience concept. To produce a high‐efficiency isolation technology with lower energy dissipation demands, this paper proposes a novel inerter‐enabled isolator (IeI) and a tailored input energy reduction‐oriented design method. The inerter‐based damper within the IeI is developed by combining the dashpot, tuning spring, and two inerters to facilitate the optimization of inerter distribution. Assuming the large‐span structure remains linear, the overall seismic input energy of the large‐span structure with IeIs and its allocation in the superstructure and additional damping are quantified using stochastic energy analysis. The advantages of the IeI over the conventional linear viscous damper (LVD) isolator are elucidated through dimensionless parametric analysis. Based on the results of parametric analysis, an input energy reduction‐oriented design method is proposed for the IeI, along with an easy‐to‐follow diagram that helps with preliminary design in practical applications. The effectiveness of the IeI and the proposed design method is validated through a design case study of a benchmark large‐span structure. The results demonstrate that the IeI reduces the seismic response of large‐span structures by simultaneously employing the input energy reduction effect of grounded inerters with the damping‐enhancing effect of inerter‐based dampers. The proposed design method effectively balances the performance of controlling the large‐span structure and the isolator displacement. Under consistent control performance and isolator displacement constraints, the IeI requires much less damping coefficient and energy dissipation capacity than the conventional LVD isolator. Moreover, leveraging the damping enhancement and input energy reduction effects, the IeI achieves comparable control performance to the conventional LVD isolator, even under stricter isolator displacement constraints.

Experimental study of earthquake input energy of low‐frequency structures equipped with a passive rate‐independent damping device

Performance of a passive rate‐independent damping device in a seismically isolated multistory building

Feasibility Study of a Novel Modal Decomposition Method for Low-Frequency Structure with Nonproportionally Distributed Rate-Independent Linear Damping

Seismic Force Modification Factor for Ductile Structures

Application of Supplementary Inerter-Based Damping Devices Alongside Unbonded Fiber-Reinforced Elastomeric Isolators

The Damping Effect on Constant-Ductility Seismic Demand Spectra of Inelastic Structures

Experimental shake table validation of damping behaviour in inerter-based dampers

Influence Analysis of Damping on Constant- Ductility Seismic Resistance Spectra for Seismic Design of Structures

Frequency-dependency/independency analysis of damping magnification effect provided by tuned inerter absorber and negative stiffness amplifying damper considering soil-structure interaction

Experimental and numerical investigation of a novel passive energy dissipation system with viscoelastic damper and angle-reaction controller

Parameter optimization of vibration control system for adjacent building structures based on negative stiffness inerter damper

Shaking table test and control effect analysis of structure with negative stiffness damped outrigger

Optimum tuning of Tuned Mass Dampers for frame structures under earthquake excitation

Shaking Table Test Studies on Adaptive-Passive Variable Frequency Gas-Spring DVA for Structural Seismic Response Mitigation

Input Energy Reduction‐Oriented Control and Analytical Design of Inerter‐Enabled Isolators for Large‐Span Structures

Damped rigid substructure system for seismic protection of structures

Experimental research and numerical simulation of a large-span isolated structure considering multi-dimensional input effects

Horizontal Shaking Table Tests on a Four-Story Prototype Structure Using Multi-Dimensional Earthquake Isolation and Mitigation Devices

Noniterative Optimization Procedure for Seismic Weakening and Damping of Inelastic Structures

Shaking table test study of a RC frame with viscous damper

An Overview of Optimal Damper Placement Methods in Structures