Abstract:In this study, we examined the thermal effects throughout the process of the placement of span-scale girder segments on a 6×110-m continuous steel box girder in the Hong Kong-Zhuhai-Macao Bridge. Firstly, when a span-scale girder segment is temporarily stored in the open air, temperature gradients will significantly increase the maximum reaction force on temporary supports and cause local buckling at the bottom of the girder segment. Secondly, due to the temperature difference of the girder segments before and after girth-welding, some residual thermal deflections will appear on the girder segments because the boundary conditions of the structure are changed by the girth-welding. Thirdly, the thermal expansion and thermal bending of girder segments will cause movement and rotation of bearings, which must be considered in setting bearings. We propose control measures for these problems based on finite element method simulation with field-measured temperatures. The local buckling during open-air storage can be avoided by reasonably determining the appropriate positions of temporary supports using analysis of overall and local stresses. The residual thermal deflections can be overcome by performing girth-welding during a period when the vertical temperature difference of the girder is within 1 °C, such as after 22:00. Some formulas are proposed to determine the pre-set distances for bearings, in which the movement and rotation of the bearings due to dead loads and thermal loads are considered. Finally, the feasibility of these control measures in the placement of span-scale girder segments on a real continuous girder was verified: no local buckling was observed during open-air storage; the residual thermal deflections after girth-welding were controlled within 5 mm and the residual pre-set distances of bearings when the whole continuous girder reached its design state were controlled within 20 mm.

Study on Temperature effect of Single Expansion Joint Bridge

Control Measures for Thermal Effects During Placement of Span-Scale Girder Segments on Continuous Steel Box Girder Bridges

Dynamical Behavior of Steel Box Girder Bridges Due to Vehicle-Induced Vibration at Expansion Joint

TEMPERATURE EFFECT ON BEHAVIOURS OF SINGLE-BRACED RETAINING STRUCTURE OF DEEP EXCAVATION

Temperature Field and Stress Field of Prestressed Concrete Box-Girder Bridge

Response and Vibration Control of Steel Box-girder Bridge When Vehicles Passing through the Expansion Joint

Investigation and Control of Cracks in Wet Joint of Concrete Box Girders

Temperature Field Characteristics and Cooling Measures of Steel Box Girder of Cross-Sea Bridge

Analysis of Temperature Stress in Bridges Considering Vertical and Transverse Temperature Gradient

Incorporating Site-Specific Weigh-in-motion Data into Fatigue Life Assessment of Expansion Joints under Dynamic Vehicle Load

SHM-based condition assessment of expansion Joints in suspension Bridges

An analysis method of vehicle–bridge coupling vibration considering effects of expansion joint parameters and its application

Experimental Study on Mix Ratio Design and Road Performance of Medium and Small Deformation Seamless Expansion Joints of Bridges

Evaluation of Performance of Bridge Deck Expansion Joints

Investigation of temperature effects on wide steel box girder of suspension bridge based on long-term monitoring data

Failure Mechanism of Expansion Joints in a Suspension Bridge

Condition Assessment of Expansion Joint of a Cable-Stayed Bridge Based on Long-Term Monitoring

Fatigue performance of an innovative shallow-buried modular bridge expansion joint

Temperature Field Boundary Conditions and Lateral Temperature Gradient Effect on a PC Box-Girder Bridge Based on Real-Time Solar Radiation and Spatial Temperature Monitoring

Performance evaluation of cable-stayed bridge expansion joints based on Lasso dimensionality reduction and temperature-displacement-correlation model

Research on Effect of Bridge-deck Pavement on Temperature Gradient