Statistical modelling of depth milling in Ti-6AL4V using abrasive water jet machining
Yakub I Mogul,Jaimon D Quadros,Sher Afghan Khan,Manoj Agrawal,Indradeep Kumar,Saboor Shaik,Chanduveetil Ahamed Saleel,Ashish Saxena
DOI: https://doi.org/10.1177/09544089231223789
2024-01-07
Proceedings of the Institution of Mechanical Engineers Part E Journal of Process Mechanical Engineering
Abstract:Proceedings of the Institution of Mechanical Engineers, Part E: Journal of Process Mechanical Engineering, Ahead of Print. Multi-objective grey relational analysis optimization technique and multiple regression analysis were employed to determine the optimum values for depth of cut, surface roughness (Ra), and kerf at entry and exit ([math] and [math]), for abrasive waterjet machining of Ti6AL4V materials. This method highlights a new process to extend the grey relational analysis technique for determining the optimum conditions for obtaining the best quality characteristics. The input parameters of the study were water pressure (Wp), transverse speed (Ts), abrasive mass flow rate (Amf), abrasive orifice size (Aos), nozzle/orifice diameter ratio (N/Odia). The experiments were conducted as per the Taguchi-based L27 orthogonal array. The grey relational analysis technique found that Ts was the most significant parameter on the combined outputs. The regression models developed had an R2 of 81.58%, 79.79%%, 77.20%, and 74.39% for depth of cut, Ra, [math] and [math], respectively. Additionally, the analysis of variance showed that Wp and Aos had a significant influence on the output parameters. The predicted values were found to be reasonably close with the experimental values, and the maximum average deviation was 8.15% for [math].
engineering, mechanical