Abstract:The primary goal of safety films for glass in buildings is to retrofit existing monolithic elements and prevent, in the post-fracture stage, any fall-out of shards. Their added value is that—as far as the fragments are kept bonded—a cracked film-glass element can ensure a minimum residual mechanical and load-bearing capacity, which is strictly related to the shards interlocking and debond. To prevent critical issues, such a mechanical characterization is both important and uncertain, and requires specific methodologies. In this regard, a dynamic investigation is carried out on fractured film-bonded glass samples, to assess their post-fracture stiffness trends and its sensitivity to repeated vibrations. The adopted laboratory layout is chosen to assess the effects of random vibrations (220 repetitions) on a total of 12 cracked specimens in a cantilever setup (with 0.5–5 m/s2 the range of randomly imposed acceleration peaks). By monitoring the cracked vibration frequency, the film efficiency and corresponding residual bending stiffness of cracked glass samples are quantified as a function of damage severity, with a focus on fragments interlock. Quantitative experimental estimates are comparatively analyzed and validated with the support of finite element (FE) numerical models and analytical calculations. As shown—at least at the small-scale level—a progressive post-fracture stiffness reduction takes place under repeated random vibrations, and this implicitly affects the residual load-bearing capacity of glass members. Most importantly, for the tested configurations, it is shown that the cracked vibration frequency is minimally affected by crack geometry, and follows a rather linear decrease with the number of imposed random impacts (up to an average of ≈20 for each sample), thus confirming the retrofit potential and efficiency in providing some mechanical capacity through fragments interlock.

Puncture Impact Test on Glass Plate Fitted with Shatterproof Window Film

Soft Impact Response of Laminated Glass Plates

Effect of shatterproof polymer film application on the fracture types and strength of glass subject to bending load

Deformation and Damage Mechanisms of Laminated Glass Windows Subjected to High Velocity Soft Impact

Investigation on Behavior of Glazing System with Elastomeric Interlayers under Blast Effects

Investigation of Dynamic Multi-Cracking Behavior in PVB Laminated Glass Plates

Modeling And Experimental Studies Of Crack Propagation In Laminated Glass Sheets

Investigation on Dynamic Propagation Characteristics of In-Plane Cracks in PVB Laminated Glass Plates

Fatigue Tests of Single Layer and Laminated Glass Plates with Point Supports

Experimental Study of Dynamic Fracture Behavior of PVB Laminated Glass by High-Speed Photography

Experimental study on mechanical behavior of PVB laminated glass under quasi-static and dynamic loadings

Experimental and analytical study on the pre-crack impact response of thick multi-layered laminated glass under hard body impact

Fracture Mechanics Analysis of Thermally Tempered Glass Plate: Fracture Induced by an Embedded Crack

Nonlinear analytical study of structural laminated glass under hard body impact in the pre-crack stage

Experimental Investigation on the Impact Resistance of Laminated Glass with Various Glass Makeups

Experimental investigation on the blast resistance of framed PVB-laminated glass

Experimental study on the gradual fracture of layers in multi-layer laminated glass plates under low-velocity impact

Effect of the tin- versus air-side plate-glass orientation on the impact response and penetration resistance of a laminated transparent armour structure

Influence of pasting films on the resistant impacting property of glass

Post-Fracture Stiffness and Residual Capacity Assessment of Film-Retrofitted Monolithic Glass Elements by Frequency Change

Different Driving Mechanisms of In-Plane Cracking on Two Brittle Layers of Laminated Glass