Abstract:The article presents the results of the development and research of the combined technological process of forming the outer and inner flanges of the lids of fractional and distillation columns on sheet blanks by the method of stamping by rolling and rotary drawing. For this purpose, equipment has been developed that allows to form both outer and inner flanges of the blank in one run of the conical roll. Studies have shown that technological capabilities of the process are limited by the risk of destruction of the top layers of the outer flange bending center and its corrugation, as well as by the neck formation or destruction of the peripheral areas of the inner flange. To assess the deformability of the outer flange, the stress-strain state of its bending center was investigated. According to the set stress values, the stress state of the material is determined, the maximum value of which on the surface of the bending zone is Formula for determining the minimum radius of the mandrel, which when using the values of the critical ductility of the material allows to prevent destruction. As well, an expression for determining the maximum width of the flange, provided that the destruction of peripheral areas is prevented, is obtained. As corrugations formation is the main danger in forming the external flanges by the stamping by rolling method (SR), the expression for determining the maximum width of the flange under the condition of a stable process is obtained. If it is necessary to get more developed flanges, it is proposed to provide thinning of their walls by rotary extraction at the second stage. When forming the inner flanges of the blank stacks radial compressive stresses and tangential tensile stresses in the material are brought about. The action of tangential stresses causes loss of stability of the flange by way of neck formation. The value of the critical strains increases with the approach to the state of plain-strain deformation. Therefore, it is recommended to develop process parameters based on construction of the critical strains diagrams.

DEVELOPMENT OF THE COMBINED TECHNOLOGICAL PROCESS OF BLANK STACKS FLANGES FORMATION BY THE METHOD OF STAMPING BY ROLLING AND ROTARY DRAWING

Ultimate Strength Evaluation of the Multistage Technological Process of Cold Sheet Stamping Technique for Manufacture of Thin-Walled Vessels

SIMULATION OF MULTI-STAGE COLD FORMING OF A THIN-WALLED VESSEL

Axial Rotary Forging of Inner Flanges at Thin Wall Tube Blanks

Finite-element Modelling of a Novel Flanging Process on a Cylinder with a Large Diameter–thickness Ratio

Flange Forming at an Arbitrary Tube Location Through Upsetting with a Controllable Deformation Zone

Analysis of a New Process for Forming Two Flanges Simultaneously in a Hollow Part by Extrusion with Two Moving Dies

Development and Implementation of Die Forging Technology Eliminating Flange Welding Operations in Conveyor Driver Forging

Bending of sheets and profiles on a four-roll machine for rocket bodies, pipe and frame products. Part 13

Theoretical and Experimental Study on the Effect of Selected Parameters in a New Method of Extrusion with a Movable Sleeve

Numerical Simulation of Double Rollers Clamping Spinning Process for Flanging

Numerical Simulation Research on A New Spinning Process: Double-Roller Clamping Spinning Process

Plastic Deformation Mechanism in Double-Roller Clamping Spinning of Flanged Thin-Walled Cylinder

System Analysis of Cold Axial Rotary Forging of Thin-Walled Tube Blanks

RADIAL EXTRUSION OF A PIPE BILLET WITH INTERNAL LEDGE. METHODS FOR CALCULATING THE TECHNOLOGICAL PARAMETERS OF EXTRUSION OF PRODUCTS WITH THE SAME RADII OF THE UPPER AND LOWER PARTS

The Numerical and Analytical Study on Stretch Flanging of V-Shaped Sheet Metal

Development of forming process for deep drawing of square cup with optimized blank holder pressure

A new tube forging process for manufacturing hollow parts with inner flange at an arbitrary location

Experimental and numerical study of the flaring process for Zircaloy tube end

Research on Plastic Deformation Behavior of Double Rollers Clamping Sheet Metal Spinning Process

Influence of Process Fluctuations on Residual Stress Evolution in Rotary Swaging of Steel Tubes