Abstract:Conventional excitation techniques such as modal impact hammer and shakers are commonly used in experimental modal testing. However, these excitation approaches require the excitation device to be in direct contact with test articles. It can result in distorted measurements, particularly for small structures, such as a MEMS cantilever and thumb nail size turbine blade. In addition, it is physically difficult or even impossible to apply these contact type excitations to some structures such as low stiffness structures or biological tissues. Moreover, these conventional excitations have limited bandwidth, usually less than 10 kHz, and thus are not applicable to extract information in higher frequency modes. Dynamic focused ultrasound radiation force has been recently used to excite structures with sizes ranging from micro to macro-scale and having a frequency bandwidth from tens of Hertz to up to 100 kHz. Therefore, it can potentially be used as an alternative, non-contact excitation method to these conventional contact excitation techniques for experimental modal analysis. Yet, this force remains to be quantified and calibrated in order to obtain the input-output relationship necessary to compute accurate frequency response functions of test structures. In this work a spherically focused ultrasound transducer (UT) is driven by double sideband suppressed carrier amplitude modulation (DSB-SC AM) signals with a scanning difference frequency and randomly varying carrier frequency. The radiated pressure field generated by the UT is experimentally measured employing a pressure microphone, which acts as a target object for the ultrasonic waves. Then, the recorded values are used to analytically evaluate the dynamic focused ultrasound radiation force. Results show that the measured radiation pressure and estimated force are characterized by a focal spot small enough to be compared to an impact hammer tip appropriate for future modal testing.

Selective excitation of microcantilever array using ultrasound radiation force.

Mode-selective noncontact excitation of microcantilevers and microcantilever arrays in air using the ultrasound radiation force

Modeling and estimation of focused ultrasound radiation force for modal excitation

Flexoelectric Control of Beams with Atomic Force Microscope Probe Excitation

Optical excitation of atomic force microscopy cantilever for accurate spectroscopic measurements

Multiflexoelectric Actuation and Control of Beams

Intermodal coupling spectroscopy of mechanical modes in microcantilevers

Q-factor control of a microcantilever by mechanical sideband excitation

Exploring the static acoustic force sensitivity using AFM micro-cantilever under single- and bimodal-frequency excitation

Estimation of the Dynamic Focused Ultrasound Radiation Force Generated by an Ultrasonic Transducer

Dual-Frequency Resonance-Tracking Atomic Force Microscopy

Dynamical Characterization of Micro Cantilevers by Different Excitation Methods in Dynamic Atomic Force Microscopy.

Ultrasensitive Mass Sensor Using the Out-of-phase Vibration Eigenstate of Intercoupled Dual-Microcantilevers

All-optical dynamic analysis of the photothermal and photoacoustic response of a microcantilever by laser Doppler vibrometry

Determining the in-plane and out-of-plane dynamic response of microstructures using pulsed dual-mode ultrasonic array transducers

Directional Energy Transfer in a Coupled Symmetrical Multifrequency Atomic Force Microscope Cantilever

Kinetic Inductive Electromechanical Transduction for Nanoscale Force Sensing

Method for efficient excitation of selective vibration modes in pulsed laser photothermal actuation

Design, fabrication and characterization of kinetic-inductive force sensors for scanning probe applications

Design, fabrication, and characterization of kinetic-inductive force sensors for scanning probe applications

Optimizing the Laser Spot Positioning on Tailored Microcantilevers Used in Atomic Force Microscopy