Abstract:Due to moisture in the ore, auxiliary material, and ladle refractory material, the hydrogen element is easily enriched in molten steel. In the metallurgy process, some hydrogen atoms form bubbles and are removed by gravity, whearas others solidify in the strand and remain in the produced steel. When the hydrogen content reaches a certain critical value, the enriched hydrogen atoms congregate to produce a white spot, which greatly reduces the strength and toughness of the steel product, and leads to brittle fracture during its service period. At present, the RH (Ruhrstahl–Heraeus) and VD (vacuum degasser) refining processes are commonly applied in steel plants, which can reduce the hydrogen content to less than 2×10−6. With the demand for high quality steel, the hydrogen content must be further decreased, so hydrogen diffusion in solid steel during the annealing process is gradually attracting increasing attention. In this study, a two-dimensional model was built to investigate the characteristic of dehydrogenation in the bloom annealing process of rail steel. Moreover, the effect of annealing temperature and annealing time on hydrogen diffusion were analyzed, and the annealing parameters were optimized. During the dehydrogenation annealing process, the hydrogen content at the corners and edges of the bloom are found to decrease rapidly, while that in the center of the strand begin to decrease in the later heating stage. As the annealing temperature increases, the starting point of dehydrogenation in the bloom center moves ahead and the maximum dehydrogenation rate increases significantly. With the extension of the soaking period, the central hydrogen content of bloom decreases significantly, but the increase rate of the dehydrogenation gradually decreases. By optimizing the bloom annealing parameters, the hydrogen content in the bloom can be steadily reduced to 0.6×10−6, which fully meets the requirement of high quality steel production.

The Purification of ZL114A Alloy by Means of Bubble Floatation

Numerical Simulation of Dehydrogenation Annealing in Bloom

Effect of New Flux on the Purification of A356 Aluminum Alloy

A New Porous Nozzle for Aluminum Melts Purification—Preparation and Mathematical–Physical Model

The impurities distribution and purification efficiency of high-purity aluminum preparation by zone melting in vacuum

Effects of Vacuum-Stirring Purification Process on Al-6Mg Alloy Melt

Optimizing degassing for particle-reinforced Al composite: Advanced ultrasonic-assisted argon treatment and numerical simulation insights

Effect of negative pressure continuous casting on hydrogen escape behavior in pure copper melt and purification mechanism

Hydrolysis-Based Hydrogen Generation Investigation of Aluminum System Adding Low-Melting Metals

Experimental Study on the Effect of Low Melting Point Metal Additives on Hydrogen Production in the Aluminum–water Reaction

The impact of frequency and power on the ultrasonic purification of aluminum alloy

Impurity distribution in preparation of high-purity aluminum by vacuum zone melting

Effect of Ar/CCl4combined purification on microstructure and mechanical properties of 2219 aluminum alloy ingot

A qualitative and quantitative investigation of nonmetallic inclusions in molten Al–Mg, Al–Cu, and Al–Zn–Mg–Cu alloys

Quantifying the effects of hydrogen concentration and cooling rates on porosity formation in Al–Li alloys

Purification of aluminium-silicon alloy by electromagnetic directional solidification: Degassing and grain refinement

Metal Substrate Enhanced Hydrogen Production of Aluminum Fed Liquid Phase Ga–In Alloy Inside Aqueous Solution

Removal of Low-Content Impurities from Pure Al by Supergravity Combined with Semi-Solid Method

Hydrogen absorption and its influence on the thermal stability of Zr 65Al 10Ni 10Cu 15 amorphous alloy

A method of further purification of zone-refined aluminum by cold-crucible levitation melting in ultra-high vacuum