Sulfur immobilization and lithium storage on defective graphene: A first-principles study

Wen Zhao,Pengcheng Chen,Peizhe Tang,Yuanchang Li,Jian Wu,Wenhui Duan

DOI: https://doi.org/10.1063/1.4862983

IF: 4

2014-01-27

Applied Physics Letters

Abstract:Motivated by the recent progresses and remaining technical challenges in Li-S battery, we employ defective graphene as a prototype cathode framework to illustrate how battery performance is influenced by the mesoporous carbon materials. We show that the immobilization of S unavoidably sacrifices its ability to further interact with Li, which leads to an enhanced cycle life but a decreased capacity. Based on our calculated results, we suggest a suitable S binding-energy range of ∼4–5 eV to balance the battery stability and capability under thermodynamic equilibrium conditions. Our results may promote the understanding and architecture design of Li-S battery.

physics, applied

What problem does this paper attempt to address?

This paper aims to solve two main problems faced in lithium - sulfur (Li - S) batteries:

1. **Insulating nature of sulfur**: Sulfur itself is an electrical insulator, resulting in poor electrochemical activity when used as a cathode material.
2. **Formation of soluble lithium polysulfide intermediate products**: The soluble lithium polysulfide formed during the charge - discharge process will lead to the loss of active substances, thus greatly shortening the cycle life of the battery.

To solve these problems, the author selected defective graphene as the prototype cathode framework and studied the mechanisms of sulfur fixation and lithium storage through first - principles calculations. Specifically, the article explored the following points:

- The effects of three typical point defects (Stone - Wales defect, single - vacancy defect, and double - vacancy defect) on sulfur fixation and lithium storage were studied.
- How these defects affect the binding energy between sulfur atoms and graphene and the further reactivity with lithium was analyzed.
- A suitable range of sulfur binding energy (4 - 5 eV) was proposed to balance the stability and capacity of the battery.

### Main findings

1. **Sulfur fixation effect**:
- Single - vacancy and double - vacancy defects can effectively fix sulfur atoms by forming covalent bonds, while Stone - Wales defects cannot effectively fix sulfur.
- Double - vacancy defects can accommodate two sulfur atoms, and these sulfur atoms can further combine with six lithium atoms.

2. **Lithium storage capacity**:
- In the double - vacancy system, a maximum of 8 lithium atoms can be attached, but only the first 6 lithium atoms have a relatively high binding energy, with an average energy release of 0.83 eV/Li.
- This corresponds to a voltage of 0.83 V, which is about 2 V lower than the experimental value, indicating that the chemical activity of sulfur is reduced in practical applications.

3. **Structural stability**:
- The formation energy of DV_Sn_Lim complexes was calculated to verify their thermodynamic stability in different chemical environments.

### Conclusion

To achieve high capacity and long cycle life, the optimized sulfur binding energy should be in the range of 4 - 5 eV. This research is not only consistent with existing experimental results but also provides theoretical guidance for designing more efficient Li - S batteries in practical applications.