Abstract:The multicore fiber amplifier, as a key component in spatial division multiplexing (SDM) communication systems, presents higher technical difficulty compared to traditional multi-channel single core fiber amplifiers, which has sparked widespread attention. To achieve balance, efficiency, miniaturization, and cost-effectiveness in the performance of multi-core optical fiber amplifiers, we propose an innovative triple cladding 13-core Er/Yb co-doped microstructured fiber (13CEYDMOF). The proposed fiber features an outer cladding with peanut-shaped air holes, which enables uniform excitation of the 13 cores using a single multimode laser pump source within the inner cladding. This approach also prevents damage or aging of the fiber's outer coating due to the pump laser. Furthermore, the design of Peanut-Shaped Air Holes effectively increases the numerical aperture (NA) of the inner cladding while reducing the outer diameter of the fiber, enhancing the fiber's mechanical flexibility. To address the coupling difficulties caused by air holes, we bi-directionally pump the 13CEYDMOFA by utilizing a combined technique of the side winding and end pumping. The experimental results show that the 13CEYDMOFA can achieve an average gain of 23.8 dB, a noise figure (NF) of ∼4.6 dB, and an inter-core gain difference of less than 2 dB in the wavelength range of 1529–1565 nm. The in-line amplified transmission experiment demonstrates that the 13CEYDMOFA is well suited for the 13 spatial channels transmission. To the best of our knowledge, this is the first time to realize high performance telecommunication band amplification in a multicore microstructure fiber.

Single-Frequency 336 W Spliceless All-Fiber Amplifier Based on a Chirally-Coupled-Core Fiber for the Next Generation of Gravitational Wave Detectors

Fiber-solid, Hybrid, Single-Frequency Laser (100 W) with a 100 MHz Repetition Rate and 1 Ns Pulse Width from a Spherical Aberration Compensated Four-Stage Nd:YVO4 Amplifier

High power, single-frequency, monolithic fiber amplifier for the next generation of gravitational wave detectors

Single-frequency fiber amplifier at 1.5 µm with 100 W in the linearly-polarized TEM00 mode for next-generation gravitational wave detectors

Influence of Bragg Reflection of Chirped Tilted Fiber Bragg Grating on Raman Suppression in High-Power Tandem Pumping Fiber Amplifiers.

435 W single-frequency all-fiber amplifier at 1064 nm based on cascaded hybrid active fibers

Novel constant-cladding tapered-core ytterbium-doped fiber for high-power fiber laser oscillator

Femtosecond Yb-doped Tapered Fiber Pulse Amplifiers with Peak Power of over Hundred Megawatts

252 W core-pumped single-frequency all-fiber amplifier at 1064 nm

700 W single-frequency all-fiber amplifier at 1064 nm with kHz-level spectral linewidth

Narrow-linewidth fiber amplifier for gravitational-wave detectors

High-gain Fluoro-Sulfo-phosphate-based Active Fiber for Compact Low-Threshold Kilohertz-Linewidth Single-Frequency Fiber Laser

A 102 W High-Power Linearly-Polarized All-Fiber Single-Frequency Laser at 1560 Nm

Monolithic tapered Yb-doped fiber chirped pulse amplifier delivering 126 μJ and 207 MW femtosecond laser with near diffraction-limited beam quality

A novel multicore Er/Yb co-doped microstructured optical fiber amplifier with peanut-shaped air holes cladding

Engineering the high-frequency components of coherent supercontinuum generation in hybrid optical fibers with yttrium aluminum garnet core

Single-mode suspended large-core chalcohalide fiber with a low zero-dispersion wavelength for supercontinuum generation

Higher-order Mode Fiber Enables High Energy Chirped-Pulse Amplification.

Four-Wave Mixing-Based Wavelength Conversion and Parametric Amplification in Submicron Silicon Core Fibers

All-fiber 30-μm core diameter Yb-doped pulse-pumped amplifier cascade generating 10 nm-bandwidth 545 kW peak power pulses

Kilowatt-level Yb-Raman fiber amplifier with narrow-linewidth and near-diffraction-limited beam quality