Abstract:In the context of the E-TEST Interreg project, Fraunhofer ILT develops high stability, narrow linewidth laser seed sources and amplifiers at a wavelength of approx. 2 m for potential usage in a third-generation gravitational wave detector: the Einstein telescope. While for such an application, there are highest demands on laser parameters such as linewidth, spectral purity, and polarization, especially stability properties such as the relative intensity noise must be optimized. To achieve highest output power stabilities, we develop a multi-stage low-noise holmium-doped fiber amplifier at a wavelength of 2095 nm, which is core-pumped by low-noise thulium-doped fiber lasers at a wavelength of approx. 1950 nm. In this article, we present the concept of the full laser system, and the achieved results for the pre-amplifier section, which perfectly fulfills the E-TEST pre-amplifier requirements. Our pump source, a thulium-doped fiber amplifier, achieves approx. 2 W output power at a wavelength of 1950 nm with 5 MHz linewidth and a polarization extinction ratio of 28 dB. With our holmium-doped fiber amplifier, we demonstrate an output power of approx. 400 mW at a wavelength of approx. 2095 nm with a linewidth of 2 MHz and a polarization extinction ratio of 18 dB. For both currently free-running systems we analyze the relative intensity noise (RIN) and obtained for example RINs of approx. 106 Hz0.5 at a frequency of 100 Hz, which shows the suitability of the concept to achieve highest stabilities. To evaluate our system, we perform a system performance analysis, where we present the influence of signal and pump wavelength, and signal and pump power on the achievable optical-optical efficiencies.

Single-frequency fiber amplifier at 1.5 µm with 100 W in the linearly-polarized TEM00 mode for next-generation gravitational wave detectors

High power, single-frequency, monolithic fiber amplifier for the next generation of gravitational wave detectors

Fiber-solid, Hybrid, Single-Frequency Laser (100 W) with a 100 MHz Repetition Rate and 1 Ns Pulse Width from a Spherical Aberration Compensated Four-Stage Nd:YVO4 Amplifier

Narrow-linewidth fiber amplifier for gravitational-wave detectors

Single-Frequency 336 W Spliceless All-Fiber Amplifier Based on a Chirally-Coupled-Core Fiber for the Next Generation of Gravitational Wave Detectors

Ultra-Low-Noise, Single-Frequency, All-PM Thulium- and Holmium-Doped Fiber Amplifiers at 1950 nm and 2090 nm for Third-Generation Gravitational Wave Detectors

301 W Narrow-Linewidth In-Band Pumped Er:Yb Co-Doped Fiber Amplifier at 1585 Nm and Related Modeling for Dynamics Study and Optimization

Tm-Doped Nonlinear Fiber Amplifier Emitting 50 fs Pulses and 20 W of Average Power at 2 μm Wavelength

A 102 W High-Power Linearly-Polarized All-Fiber Single-Frequency Laser at 1560 Nm

Kilowatt-level Yb-Raman fiber amplifier with narrow-linewidth and near-diffraction-limited beam quality

15 W High OSNR Khz-Linewidth Linearly-Polarized All-Fiber Single-Frequency MOPA at 16 Μm

Femtosecond Yb-doped Tapered Fiber Pulse Amplifiers with Peak Power of over Hundred Megawatts

15 W high OSNR kHz-linewidth linearly-polarized all-fiber single-frequency MOPA at 1.6 μm.

Kilowatt-level ytterbium-Raman fiber amplifier with a narrow-linewidth and near-diffraction-limited beam quality

Yb-Doped All-Fiber Amplifier with Low-Intensity Noise in Mhz Range Oriented to Space-Borne Gravitational Wave Detection

414.9 W In-Band Pumped Er/Yb Co-Doped Fiber Amplifier Seeded by a Random Fiber Laser.

13.9-Mj All Fiber Wide Band Ytterbium-Doped Fiber Amplifier

1010 nm Directly LD-Pumped 6kW Monolithic Fiber Laser Employing Long-Tapered Yb3+-Doped Fiber

Highly efficient Er/Yb-codoped fiber amplifier with an Yb-band fiber Bragg grating.

High power, continuous-wave, single frequency fiber amplifier at 1091 nm and frequency doubling to 545.5 nm

Efficient 1.6 μm linearly-polarized single-frequency phosphate glass fiber laser