Abstract:The clearance flow of compressor variable stator vanes has a significant impact on compressor performance. Most clearance flow experimental research work has been carried out in compressor cascades with lower turning angle (lower load). The clearance flow in a higher load compressor cascade is relatively more complicated due to three-dimensional (3D) flow separation. In the present work, the effects of different heights and locations of clearances in a compressor cascade on aerodynamic performance and separation flow were investigated experimentally in a low-speed plane cascade wind tunnel. The objective of this investigation is to study the characteristics of different clearance configurations depending on the clearance height and the clearance axial position, and make an attempt to verify the possibility of a local clearance flow that improves the performance. The cascade outlet section aerodynamic parameters were measured by L five-hole probe. The ink-trace flow visualizations on the cascade surface and lower end wall were performed. The results show that with the increase in clearance size, the core area of high loss is moving to the end wall and the morphology of limiting streamlines on the suction surface changes gradually from separation lines to reattachment lines. The separation lines on end wall gradually moved to the middle of the cascade and the separation area increased gradually. The above reasons caused high loss zone gradually extended to the end wall. Thus, the loss at mid-span declined slightly while the loss on the end wall was increasing. Otherwise, cascade load reduced significantly when the clearance height became 3mm, and the change magnitude of limiting streamline morphology in the flow field which was influenced by clearance flow at the rear of the blade reached to a minimum. So the loss and load came to a minimum, respectively. The impact of the clearance in the rear of a blade on loss and flow is weaker than the other schemes, with a slightly larger loss and separation with respect to the original scheme without a clearance. It may be expected to improve the cascade performance further by an appropriate design of clearance near the trailing.

Influence of key geometric parameters on the aerodynamic performance of a supersonic compressor cascade

Performance Sensitivity Analysis and Aerodynamic Optimization of Compressor Cascades by a Turbulence Adjoint Method

Aerodynamic Design Method and Experimental Investigation of a High-Load Supersonic Compressor Cascade

Aerodynamic Optimization and Mechanism Investigation on Performance Improvements in a Transonic Compressor Cascade

Aerodynamic Design of Supersonic Compressor Cascade and Vorticity Dynamic Diagnosis of Flow Field Structure

Influence of Additional Leading-Edge Surface Roughness on Performances in Highly Loaded Compressor Cascade

Study on Aerodynamic Optimal Super/transonic Turbine Cascade and Its Geometry Characteristics

The effect of different clearance geometry configurations on aerodynamic performance in a high-load compressor cascade

Experimental Investigation of the Transonic Shock Oscillation Characteristics in a Heavy-Duty Gas Turbine Compressor Cascade

Variations of the Shock and Secondary Flow Structure in a Transonic Compressor Cascade with Outlet Back Pressure

Influence of Bionic Leading-Edge Tubercles on Cascade Performance in a Compressor With Different Solidities

Numerical Study On End-Wall Flow In Highly Loaded Supercritical Compressor Cascades

Experimental study on the effect of fluidic oscillator jet position on the performance of a high speed compressor cascade

Numerical Investigations on Effects of Inlet Boundary Layer Characteristics on Aspirated Compressor Cascade

Experiment and Numerical Simulation of the Performance on Scaled Compressor Cascade and Development of a Prediction Model

Experimental Investigation on a High Subsonic Compressor Cascade Flow

Aerodynamic Performance Evaluation of Subsonic Compressor Cascade Blade with Leading-Edge Damage

Effects of Number of Bleed Holes on Shock-Wave/Boundary-Layer Interactions in a Transonic Compressor Stator

Influence of backward-facing step (BFS) on three-dimensional flow behavior in transonic compressor cascade

Study on Flow Structure of a Highly-Loaded Compressor Cascade Designed with Active and Passive Flow Control Methods

Experimental study on multi-angle pulsed jet actuators for controlling corner separation flow in a compressor cascade