Abstract:Fabrication of oxide thin film transistor (TFT) arrays by inkjet printing with small spacing was investigated, aiming at printing high resolution display backplanes. Two processes are involved during the printing and drying of oxide ink drops; the initial ink drop spreads to a large size upon landing on a substrate and then shrinks to a small size after the solvent dries out. The spreading of the ink drop determines how close two ink drops can be placed and the shrinkage of the ink drop after drying determines the final thickness of the printed dot. It was found that by hydrophobic treatment of the substrate surface with hexamethyldisilazane (HMDS) and octadecyltrichlorosilane (OTS) assembly, the minimum spacing (center-to-center distance) of the printed oxide dot array was reduced from over 80 mu m to 45 mu m (HMDS treated) and 35 mu m (OTS treated), while the dot diameters simultaneously decreased from 70 mu m to 20 mu m (HMDS treated) and 15 mu m (OTS treated). However, too much shrinking caused random movement of the ink drops and an increase of oxide layer thickness, both of which are detrimental to the performance of printed TFTs. To overcome these problems, the ink viscosity was adjusted by adding polyvinylpyrrolidone (PVP) to the ink. With the increase of ink viscosity, the random movement of the ink drops was suppressed and the smallest spacing of 50 mu m was achieved for printed oxide TFT arrays. Printed IGZO-TFTs annealed at 350 degrees C exhibited the highest mobility of about 6.2 cm(2) V-1 s(-1) and on-to-off current ratio of more than 10(7).

Newly developed silver nanoparticle ink for organic TFT circuits fabricated with high resolution printing system

Development of a silver nanoparticle ink for fine line patterning using gravure offset printing

Development of Silver Nanoparticle Ink for Printed Electronics

Nano-organic silver composite conductive ink for flexible printed circuit

Facile Inkjet-Printing Self-Aligned Electrodes for Organic Thin-Film Transistor Arrays with Small and Uniform Channel Length

Low-temperature reducible particle-free screen-printable silver ink for the fabrication of high conductive electrodes

Direct Patterning by Inkjet Printing 3-Mercaptopropionic Capped Nano Silver Suspension

Direct Inkjet Printing of Silver Source/Drain Electrodes on an Amorphous InGaZnO Layer for Thin-Film Transistors.

Inkjet Printed Fine Silver Electrodes for All-Solution-Processed Low-Voltage Organic Thin Film Transistors

Direct Inkjet Printing of Silver Source/Drain Electrodes on an Amorphous InGaZnO Layer for Thin-Film Transistors

Synthesis of monodisperse silver nanoparticles for ink-jet printed flexible electronics

Patterning of High-Viscosity Silver Paste by an Electrohydrodynamic-Jet Printer for Use in TFT Applications

Cost-effective Silver Nano-Ink for Inkjet Printing in Application of Flexible Electronic Devices

Preparation of a Low Temperature Sintering Silver Nanoparticle Ink and Fabrication of Conductive Patterns on PET Substrate

Direct Writing Highly Conductive Silver Pattern on Flexible Substrate Based on Particle-Free and Ionic Liquid-Assisted Ink

Printed Thin-Film Transistors with Functionalized Single-Walled Carbon Nanotube Inks

Inkjet printing of oxide thin film transistor arrays with small spacing with polymer-doped metal nitrate aqueous ink

Preparation, Characterization and Reaction Mechanism of A Novel Silver-Organic Conductive Ink

Green Approach to Prepare Silver Nanoink with Potentially High Conductivity for Printed Electronics

An Approach to a Silver Conductive Ink for Inkjet Printer Technology

Inkjet Printing of Nanosized Silver Colloids