Abstract:Despite the fact that many tribological components are designed to operate with a comparatively thick film of lubricant, the bearing surfaces often still deteriorate with time as hard particulate contaminants are swept through the bearing gap. These may arise from the external environment or, perhaps, be wear debris from other pairs of surfaces lubricated by the same fluid. In order to investigate this phenomenon experimentally it is necessary to develop a predictable hydrodynamic film between the test surfaces which can be contaminated by small volumes of carefully graded abrasive particles. Here we describe the use of a foil bearing to generate such films between 10 and 50 μm thick to which contaminants such as powdered quartz or finely divided diamond can be added. As the ratio of the characteristic particle size to film thickness is varied not only do the wear rates of the solid surfaces change but examination of the wear tracks suggests that very different mechanisms of material loss come into operation. When the size ratio is low the worn surface of the cylinder is covered by what appears to be small erosion pits; these display virtually no alignment in the direction of relative sliding and it seems that the particles tumble and roll freely through the gap. Above some critical value of the ratio the appearance of the surface changes dramatically to a grooved or micro-machined surface with all the grooves aligned in the sliding direction. A relatively simple theoretical model is developed, based on what happens to a typical particle, which goes some way to explaining these observations. As well as being consistent with the observed transition from “tumbling” to “grooving”, the model can also explain why increasing the hardness differential between the hard and the soft surfaces does not always lead to a reduction in damage to the harder member of the pair.

DEVELOPMENT OF DESIGN CRITERIA FOR A DRY FILM LUBRICATED BEARING SYSTEM

Lubrication Performance Analysis of Lead-Bismuth Internal-Feedback Bearings in the Nuclear Main Pump System

Toward Low Friction in High Vacuum by Designing Textured A-C/il Duplex Lubricating Film

Monitoring of Lubricant Film Failure in a Ball Bearing Using Ultrasound

Experimental and Numerical Study of the Influence of Loading Direction on the Lubrication and Cooling of Self-Circulating Oil Bearing System Applied in Internal Gear Pumps

Experimental and Numerical Analysis of a Self-Circulating Oil Bearing System for Gear Pumps

Experimental investigations to assess surface fatigue failure in rolling contact bearing

Vacuum tribological properties in Cr-doped H-DLC self-lubricating radial spherical plain bearings

Investigation of hydrodynamic lubricant film breakdown between the journal and bearing in a high-speed coolant pump of electric vehicles

Amorphous Carbon Films in Situ Formed from PTFE Transfer Layer in Solid Lubricated Cryogenic Turbopump Bearings

Experimental study on the feasibility of alternative materials for tilting pad thrust bearings operating in transition to mixed friction

Investigations on Ways to Improve the Scuffing and Wear Behavior of Oil-Free Water-Based Lubricants for Gear Applications

Experimental Investigation of Lubrication Oil Film Dynamics in a Typical Aero-Engine Bearing Chamber Environment

Dynamic Performance of an Oil Starved Squeeze Film Damper Combined With a Cylindrical Roller Bearing

Study on electric erosion in grease lubrication using optical interference method

Mechanisms of abrasive wear in lubricated contacts

Simulation and Experimental on Thermal Behavior of Hydrostatic Thrust Bearing Based on Superhydrophobic/oleophobic Surface

Friction and wear performance of polyether ether ketone (PEEK) polymers in three lubrication regimes

Investigation of Roller Bearing Cage Pocket Lubrication and Friction

Study on the tribological performance of self-lubricating thrust ball bearings with different embedded features

Investigation of Graphene Platelet-Based Dry Lubricating Film Formation in Tribological Contacts