Abstract:Structural Health Monitoring, Ahead of Print. This article presents an approach to identify naturally developed damage in low-speed bearings using waveform-similarity-based clustering of acoustic emissions (AEs) under fatigue loading. The approach is motivated by the notation that each recorded AE signal from a particular damage is defined by the convolution of the source signal, transfer function of the propagation path and transfer function of the utilised sensor, and may thusly be used to identify consistent AE sources, for example due to crack growth. A sequential clustering procedure is proposed, that is based on waveform cross-correlation. The supporting theoretical background of waveform similarity, rooted in an analytical formulation of waveform propagation and transmission in complex structures, is discussed. The presented methodology is evaluated through application to AE data obtained in a low-speed run-to-failure experiment utilising a densely instrumented purpose-built linear bearing segment. The implemented sensor system comprises arrays of three types of AE transducers, that is relatively low - (40–100 kHz), mid - (95–180 kHz) and high-frequency (180–580 kHz), that are situated on both the raceways and supporting substructures of either side of the bearing. Over the course of 225,000 cycles of extension and retraction, wear has been developed. A total of about ∼2,300,000 AE signals have been recorded. Analysis of the recorded data suggests the rate of degradation increases from around 70,000 cycles onwards. Highly consistent structures of clusters indicative of a localised defect in the raceway have been identified from around 170,000 cycles onwards. These clusters are characterised by hit-rates in the range of 1–2 hits per cycle and an average similarity of 93%, they comprise about half the AE activity for the periods they have been identified for. These results highlight that the proposed cross-correlation-based clustering of AE waveforms and identification of multi-channel formations in said clusters compose a suitable methodology for assessment of damage in low-speed roller bearings.

Monitoring of Lubricant Film Failure in a Ball Bearing Using Ultrasound

Online monitoring of oil film thickness of journal bearing in aviation fuel gear pump

Instrumentation of a Rolling Bearing with a Thin Film Piezo Coating for Oil Film Measurement

Application Study of Acoustic Reflectivity Based on Phased Array Ultrasonics in Evaluating Lubricating Oil Film Thickness

A comprehensive review of non-destructive methods for bearing lubricating oil film thickness measurement

Wear monitoring method of water-lubricated polymer thrust bearing based on ultrasonic reflection coefficient amplitude spectrum

Influence of Grease Contamination on Acoustic Emission Monitoring of Low-speed Roller Bearings

Wear monitoring of bearing steel using electrostatic and acoustic emission techniques

Journal Bearing Wear Monitoring via On-Line Visual Ferrography

An accurate measurement method for center oil film thickness in high-speed roller bearing using ultrasound

Contactless measurement of hydrostatic bearing lubricating film using optical point tracking method

Toward diagnostics of water-lubricated bearings of naval vessels by vibration analysis

DEVELOPMENT OF DESIGN CRITERIA FOR A DRY FILM LUBRICATED BEARING SYSTEM

Acoustic emission monitoring of naturally developed damage in large-scale low-speed roller bearings

An Attempt to Evaluate Insufficient Supply of Oil in Ball Bearing with Ultrasonic Technique

Low Cost Wear Monitoring of Bearing Shell in Connecting Rod via I-kaz Method

Calibration of Oil Film Thickness Acoustic Reflection Coefficient of Bearing under Multiple Temperature Conditions

Rolling Bearing Condition Monitoring Technique Based on Cage Rotation Analysis and Acoustic Emission

Film-Thickness Identification Method and Lubrication Characteristic Experiment of Full-Size Water-Lubricated Stern Bearing under Offset Load

Fault Diagnosis for Abnormal Wear of Rolling Element Bearing Fusing Oil Debris Monitoring

Vibrations and film thickness in grease-lubricated deep groove ball bearings