Abstract:Indoor air pollution is responsible for the annual premature death of millions of people worldwide. Volatile organic compounds (VOCs) are among these pollutants with proven detrimental effects on occupants’ health. Plasma-based methods’ capabilities for VOCs degradation have motivated designers to employ these methods for purifying indoor air environment. It has been demonstrated that utilizing a dual functional adsorbent/catalyst (DFA/C) in a plasma system can significantly enhance the VOCs removal and the system’s energy efficiency. However, selecting an appropriate DFA/C has remained a challenge. For the first time, this research attempted to utilize metal organic frameworks (MOFs) as DFA/Cs for a plasma-driven catalytic reactor. Accordingly, three different MOFs, MIL-101 (MIL: Material Institute Lavoisier), MIL-53, and CPM-5 (CPM: Crystalline Porous Material-5) were synthesized through microwave and solvothermal methods. Furthermore, for the first time, a mechanochemical method was developed to synthesize CPM-5. To test the performance of the developed MOFs, a non-thermal plasma dielectric barrier discharge (DBD) system was designed, set-up and calibrated. Several adsorption and oxidation experiments were performed to study the physical and chemical behaviors of these MOFs for the removal of toluene and isobutanol. Also, the effect of the presence of humidity on the adsorption/oxidation capacities of MOFs was investigated. Further analyses were carried out to study the surface characteristic of the developed MOFs using X-ray diffraction (XRD), scanning electron microscopy (SEM), BET surface area analysis, and thermogravimetric analysis (TGA). The results for microwave-synthesized MIL-53 and CPM-5 and also solvothermal-synthesized MIL-101 showed a good crystallinity, very high specific surface area (SLangmuir: 1275-3747 m2/g), and acceptable thermal stability. In the case of mechanochemical-synthesized CPM-5, the TGA analysis showed a similar thermal stability compared to the microwave-synthesized CPM-5. However, the SEM micrographs showed a formation of different morphology of crystallites. Also, the surface area of the mechanochemical-synthesized CPM-5 was lower than the one synthesized by the microwave method. The adsorption isotherms of toluene and isobutanol demonstrated the physisorption of these MOFs. This result was also confirmed by TGA characterization of samples before and after toluene adsorption. In addition, oxidation evaluation studies exhibited VOCs removal potential over these MOFs. MIL-101 and MIL-53 exhibited superior adsorption and oxidation ability than CPM-5 in most cases. Results also showed higher adsorption capacity of MIL-101 than MIL-53 in dry conditions but almost the same oxidation efficiency. Nevertheless, adsorption/oxidation capacities of MIL-53 surpassed MIL-101 in the presence of 30% relative humidity. Moreover, Fourier transform infrared spectroscopy (FTIR) showed the stable structure of the examined MOFs after plasma-catalytic reactions, which indicated they were easy to be regenerated. During the course of plasma-catalytic oxidation of toluene and isobutanol, different organic by-products and ozone were detected. Results showed utilization of a MOF as catalyst in the plasma system can reduce the downstream ozone concentration. Moreover, the presence of humidity suppressed the amount of ozone generation. In conclusion, results demonstrated the potential capacity of MIL-53 and MIL-101 as DFA/Cs in plasma-catalyst air purification system.

Chromium-based metal-organic framework MIL-101 as a highly effective catalyst in plasma for toluene removal

Plasma Induced Toluene Decomposition on Alumina-Supported Mn-Based Composite Oxides Catalysts

Metal Organic Frameworks as Dual Functional Adsorbent/Catalysts for Plasma Air Purification Systems

Boosting Chlorobenzene Oxidation over MIL-101(Cr) Derived CrOx Catalysts: the Stepwise Regulation of CrOx Clusters and Oxygen Species by Calcination Atmospheres

Remarkable Promotion Effect of Lauric Acid on Mn-MIL-100 for Non-Thermal Plasma-Catalytic Decomposition of Toluene

Stable Metal-Organic Frameworks based mixed tetramethylammonium hydroxide for toluene adsorption

Plasma-catalytic oxidation of toluene over MCeZrO x /TiO 2 (M = Cu, Mn, Ni and Co) catalysts using a dielectric barrier discharge reactor

Regulating oxygen vacancies and hydroxyl groups of α-MnO2 nanorods for enhancing post-plasma catalytic removal of toluene

Non-thermal plasma coupled with MOF-74 derived Mn-Co-Ni-O porous composite oxide for toluene efficient degradation.

Realizing Toluene Deep Mineralization by Coupling Nonthermal Plasma and Nitrogen-Enriched Hollow Hybrid Carbon.

Bimetallic Mn-Ce loaded on different zeolite carriers applied in the toluene abatement in air by non-thermal plasma DDBD reactor

Enhancement of Flue Gas Low-Concentration Toluene Removal in Pulsed Plasma Coupling with Porous Ceramic Modified Catalyst Reactor

Non-thermal plasma synthesis of supported Cu-Mn-Ce mixed oxide catalyst towards highly improved catalytic performance for volatile organic compound oxidation

Core-Shell Composite MIL-101(Cr)@TiO2 for Organic Dye Pollutants and Vehicle Exhaust

Controlled Thermal Conversion Strategy to Provide Metal–Organic Framework-Supported Composite Catalysts

Nonthermal plasma coupled with Mn/N-doped carbon catalysts for highly efficient removal of toluene

By-product reduction for the non-thermal plasma removal of toluene using an α-MnO 2 /Cordierite honeycomb monolithic catalyst in a honeycomb structure

Plasma-Enhanced Chemical Looping Oxidative Coupling of Methane through Synergy between Metal-Loaded Dielectric Particles and Non-Thermal Plasma

Synthesis of acidic MIL-125 from plastic waste: Significant contribution of N orbital for efficient photocatalytic degradation of chlorobenzene and toluene

Material extrusion additively manufactured alumina monolithic structures to improve the efficiency of plasma-catalytic oxidation of toluene

Ti-grafted MIL-101 as hydrophilic catalyst for efficient oxidative desulfurization of dibenzothiophene with hydrogen peroxide