Abstract:Non-thermal plasma (NTP) coupled with catalyst is a cutting-edge technique for the abatement of chlorinated volatile organic compounds (Cl-VOCs), which are typically chemically stable, highly toxic and non-biodegradable. In this study, different morphologies of 3D MnO 2 catalysts were fabricated facilely through a hydrothermal method and coupled with NTP for trichloroethylene (TCE) degradation. Among the various catalysts tested, MnO 2 IV exhibited the highest TCE degradation performance, with removal efficiency, mineralization and energy yield ranging from 44.3% to 94.8%, 28.9% to 90.1% and 5.76 to 2.31 g/kWh, respectively, at voltage levels between 7 and 11 kV. The relationship between the physicochemical properties of the catalysts and their degradation performance was established through various characterization methods. The exceptional catalytic efficiency of MnO 2 IV can be ascribed to its hierarchical flower-like structure, the greatest specific surface area (120 m 2 /g), the weakest Mn-O bonds, increased lattice defects and oxygen vacancies, and lower H 2 reduction temperature. These characteristics facilitate enhanced transfer, adsorption, and utilization of reactive oxygen species in NTP on the surface of MnO 2 IV, promoting the deep oxidation of TCE. The optimization of operational parameters was achieved using response surface methodology, with results indicating that the applied voltage exerted the greatest influence on both the mineralization rate and energy yield. The optimal operating conditions were determined, with initial TCE concentration, applied voltage, and gas flow rate values identified as 393 ppm, 7.3 kV, and 0.83 L/min, respectively. Lastly, the TCE degradation mechanism in the NTP-MnO 2 catalyst system was hypothesized based on the identification of various plasma reactive species and organic intermediates. This study provides new insights for the improvement of the VOCs oxidation performance in plasma catalytic system.

Material extrusion additively manufactured alumina monolithic structures to improve the efficiency of plasma-catalytic oxidation of toluene

Plasma Induced Toluene Decomposition on Alumina-Supported Mn-Based Composite Oxides Catalysts

VOCs degradation with non-thermal plasma and Ag-MnOx catalysis

Enhancement of Toluene Removal over Α@δ-Mno2 Composites Prepared Via One-Pot by Modifying the Molar Ratio of KMnO4 to MnSO4·H2O

By-product reduction for the non-thermal plasma removal of toluene using an α-MnO 2 /Cordierite honeycomb monolithic catalyst in a honeycomb structure

Realizing Toluene Deep Mineralization by Coupling Nonthermal Plasma and Nitrogen-Enriched Hollow Hybrid Carbon.

Non-thermal plasma coupled with MOF-74 derived Mn-Co-Ni-O porous composite oxide for toluene efficient degradation.

Regulating oxygen vacancies and hydroxyl groups of α-MnO2 nanorods for enhancing post-plasma catalytic removal of toluene

In-plasma Catalytic Degradation of Toluene over Different MnO 2 Polymorphs and Study of Reaction Mechanism

Facile fabrication of three-dimensional MnO 2 for trichloroethylene degradation by plasma catalysis

Nonthermal plasma coupled with Mn/N-doped carbon catalysts for highly efficient removal of toluene

Enhancing Low-Temperature Catalytic Performance for Toluene Oxidation Using In-Situ Pyrolyzed Mn-Doped MOF-74 Derived MCNOx Catalysts

Post Plasma Catalysis For The Removal Of Acetaldehyde Using Mn-Co/Hzsm-5 Catalysts

Adjusting Ag0 on Oxygen-Deficient Ag/MnO2 Through Electronic Metal-Support Interaction to Enhance Mineralization of Toluene in Post-Plasma Catalytic System

Nonthermal plasma catalysis using ferrites as an efficient catalyst for toluene degradation

Optimizing the CeO2-MnO2 Interface Via H2O2 Etching for Surface Lattice Oxygen Activation in the Plasma Catalytic Degradation of Trimethylamine

Non-thermal plasma synthesis of supported Cu-Mn-Ce mixed oxide catalyst towards highly improved catalytic performance for volatile organic compound oxidation

Fabrication of γ-Al2O3 Nanoarrays on Aluminum Foam Assisted by Hydroxide for Monolith Catalysts

Nonthermal Plasma-Assisted Catalytic Oxidation of Carbon Monoxide over CuOx@γ-Al2O3: Understanding Plasma Modification of Catalysts and Plasma–Catalyst Synergy

Tailored monolithic catalyst and reactor by direct photo-curing 3D printing for oxidative desulfurization of fuels

Toluene Decomposition by Non-Thermal Plasma Assisted 2d Coox/Al2o3: the Relative Contributions of Specific Energy Density of Plasma, Co 3+ and Oxygen Vacancy