Abstract:The influence of Mo (10‐40at.%) additions to Cr‐8at.%Si was systematically studied by producing arc melted alloys and analyzing the as‐cast and annealed microstructures as well as the oxidation resistances. The majority of the alloys contained a solid solution A2 matrix with the intermetallic A15 = (Cr,Mo)3Si phase. The oxidation resistance was tested by thermogravimetric analysis (TGA) at 1200 °C in air for 50 and 100 h. Samples were characterized by XRD, SEM and EPMA (WDS). The studied Cr‐xMo‐8Si alloy series showed a beneficial effect of Mo on the corrosion behavior of the annealed arc melted alloys exposed at 1200 °C in air. An increased amount of A15 led to the formation of a continuous SiO2 scale beneath the Cr2O3 layer during high temperature exposure. The internal SiO2 layer inhibited further internal oxidation of the A15 phase. Prior annealing also influenced the oxidation behavior of the alloys. Higher annealing temperatures, resulted in an overall reduced fraction of the A15 phase, as well as coarsening, but also showed a more uniform size and distribution of the precipitates, which seems to benefit the formation of a protective duplex oxide scale. Cr‐25Mo‐8at.%Si annealed at 1350 °C for 100 h, showed the most promising oxidation behavior after exposure in air at 1200 °C for 100 h. For all of the investigated Mo contents, no nitridation was observed when compared to the Cr‐8Si reference composition. The oxide scale adhesion also was improved. For Mo >25 at.% no spallation was observed. Evaluation of the TGA data showed it follows the paralinear law, with both the growth rate, kp, and volatilization rate, kv, of Cr2O3 being reduced by adding 10‐25 at.% Mo. A binary Cr/Mo‐Si phase diagram was generated for the studied alloy series in order to determine accurate annealing conditions and estimate the stability range of the metastable σ phase. This article is protected by copyright. All rights reserved.

Effect of microalloying with silicon on high temperature oxidation resistance of novel refractory high-entropy alloy Ta-Mo-Cr-Ti-Al

High-Temperature Oxidation Behavior of Refractory High-Entropy Alloys: Effect of Alloy Composition

Enhanced Oxidation Resistance of MoTaTiCrAl High Entropy Alloys by Removal of Al

THE INFLUENCE OF Mo‐CONTENT AND ANNEALING ON THE OXIDATION BEHAVIOUR OF ARC‐MELTED Cr‐xMo‐8Si ALLOYS

Oxidation Behavior between 700 and 1300 °C of Refractory TiZrNbHfTa High-Entropy Alloys Containing Aluminum

Oxidation behavior of Ti-Nb-Mo-Al-Six refractory high entropy alloy at 1000°C

Effects of Ta Content on Microstructure and Oxidation Behavior of AlCoCrFeNiYTax High Entropy Alloy

The Effects of Alloying Elements Cr, Al, and Si on Oxidation Behaviors of Ni-Based Superalloys

New insights in the oxidation behavior of (FeCoCrNi)94Al4Ti2Si high entropy alloys at 1100 °C

Improving oxidation resistance of TaMoZrTiAl refractory high entropy alloys via Nb and Si alloying

Oxidation Behavior Between 700 And 1300 Degrees C Of Refractory Tizrnbhfta High-Entropy Alloys Containing Aluminum

Oxidation and Hot Gas Corrosion of Al–Cr–Fe–Ni‐Based High‐Entropy Alloys with Addition of Co and Mo

Effect of Al content on the microstructure, properties, and oxidation behaviors at 900 °C of (MoNbCoCrAlxSi0.2)70Ti30 refractory high-entropy alloys coatings fabricated by electron beam cladding

Study on the high-temperature oxidation of AlCrFeCoNi-based high-entropy alloys with trace Si additions

Effects of Al/Si on the oxidation behavior of a TiZrV0.5Nb0.5 refractory high entropy alloy at 1000 °C

High-Temperature Oxidation of NbTi-Bearing Refractory Medium- and High-Entropy Alloys

Microstructure and Composition Evolution of a Fused Slurry Silicide Coating on MoNbTaTiW Refractory High-Entropy Alloy in High-Temperature Oxidation Environment

Effect of Al Content on the Microstructure, Properties, and Oxidation Behaviors at 900 ℃ of (monbcocralxsi0.2)70ti30 Refractory High-Entropy Alloys Coatings Fabricated by Electron Beam Cladding

High-Temperature Oxidation Behavior of Al-Co-Cr-Ni-(Fe or Si) Multicomponent High-Entropy Alloys

Oxidation behavior of AlCoCrFeNiSi high-entropy alloys at 1100 °C

Effects of Ta Addition on the Microstructure, Compression Properties and Oxidation Resistance of NiAl-Cr(Mo) Alloy