Abstract:Creep age forming (CAF) technology has been successfully applied to the manufacture of large aluminum alloy components. As the component size is large, the loading rate of different parts of the component has a large deviation. In order to fully understand the CAF process of large components, the effects of loading rate on creep aging (CA) treatment of Al-Li alloy were investigated at 180 degrees C for 18 h, including the deformation, mechanical properties, and microstructure evolution. Compared with different loading rates (2 N/s, 1 N/s and 0.5 N/s) in the CA experiment, the loading rate can be found to effectively affect the CA behavior of the materials. On the one hand, higher loading rate (2 N/s) is beneficial to the accumulation of creep strain in the process of CA, the increase of loading rate will cause the creep strain to increase suddenly. On the other hand, the increase of loading rate will promote the nucleation of T-1 phase, refine the precipitate, limit the precipitation of theta' phase, shorten the peak-aged time, reduce the peak aging strength and increase the elongation. In addition, the increase of loading rate also promotes the transition from brittle fracture to mixed fracture. The evolution of microstructure during aging was observed by transmission electron microscope (TEM). It is confirmed that the effect of loading rate on creep behavior is mainly caused by the change of dislocation due to the difference of loading rate, which leads to the change of evolution law of precipitated phase. Moreover, the mechanism of material properties and creep strain change is explained.

Creep Deformation of Carbon-Based Cathode Materials for Low-Temperature Aluminum Electrolysis

High Temperature Creep Behaviour of Carbon-Based Cathode Material for Aluminum Electrolysis

Simulation of the Creep Strain of Carbon-Based Cathode Material in the Aluminum Electrolysis

High‐Temperature Creep Deformation and Change in Porous Structure of Graphite Cathode in Aluminum Electrolysis Process

Correction to: Creep Deformation of Carbon-Based Cathode Materials for Low-Temperature Aluminum Electrolysis

Influence of Current Density on the Microstructure of Carbon-Based Cathode Materials During Aluminum Electrolysis

Ab initio investigations of crystal transition for graphite intercalation compounds during aluminum electrolysiss

Creep Aging Properties Variation and Microstructure Evolution for 2195 Al–Li Alloys with Various Loading Rates

Expansion and creep deformation with microstructure evolution in graphite cathode under constant pressure

Compressive creep aging behavior and microstructure evolution in extruded Al-Mg-Si alloy under different temperature and stress levels

Creep Ageing Behaviour Assisted by Electropulsing under Different Stresses for Al−Cu−Li Alloy

Study on the Creep Properties and Microstructures of EW75 Alloy

Thermal Creep Behavior and Creep Crystallization of Al-Mg-Si Aluminum Alloys

Finite element modeling of creep behavior of porous nickel alloys at the operating conditions of molten carbonate fuel cell

Study on Multi-Step Creep Aging Behavior of Al-Li-S4 Alloy

Structural Evolution and Transitions of Mechanisms in Creep Deformation of Nanocrystalline FeCrAl Alloys.

Ab Initio Investigations of Effect of Sodium Intercalation on the Mechanical Performance of Graphitic Cathode During Aluminium Electrolysis

Creep behavior and mechanical properties of Al-Li-S4 alloy at different aging temperatures

Borated graphite cathodes for low-temperature aluminum electrolysis

Compression creep behaviour of Al-8.5Fe-1.3V-1.7Si alloy

Creep Behavior and a Deformation Mechanism Based Creep Rate Model under High Temperature and Low Stress Condition for Single Crystal Superalloy DD5