Abstract:In bridge structure monitoring and evaluation, deformation data serve as a crucial basis for assessing structural conditions. Different from discrete monitoring points, spatially continuous deformation modes provide a comprehensive understanding of deformation and potential information. Terrestrial laser scanning (TLS) is a three-dimensional deformation monitoring technique that has gained wide attention in recent years, demonstrating its potential in capturing structural deformation models. In this study, a TLS-based bridge deformation mode monitoring method is proposed, and a deformation mode calculation method combining sliding windows and surface fitting is developed, which is called the SWSF method for short. On the basis of the general characteristics of bridge structures, a deformation error model is established for the SWSF method, with a detailed quantitative analysis of each error component. The analysis results show that the deformation monitoring error of the SWSF method consists of four parts, which are related to the selection of the fitting function, the density of point clouds, the noise of point clouds, and the registration accuracy of point clouds. The error caused by point cloud noise is the main error component. Under the condition that the noise level of point clouds is determined, the calculation error of the SWSF method can be significantly reduced by increasing the number of points of point clouds in the sliding window. Then, deformation testing experiments were conducted under different measurement distances, proving that the proposed SWSF method can achieve a deformation monitoring accuracy of up to 0.1 mm. Finally, the proposed deformation mode monitoring method based on TLS and SWSF was tested on a railway bridge with a span of 65 m. The test results showed that in comparison with the commonly used total station method, the proposed method does not require any preset reflective markers, thereby improving the deformation monitoring accuracy from millimeter level to submillimeter level and transforming the discrete measurement point data form into spatially continuous deformation modes. Overall, this study introduces a new method for accurate deformation monitoring of bridges, demonstrating the significant potential for its application in health monitoring and damage diagnosis of bridge structures.

Subsidence analysis of ELH Bridge through ground-based interferometric radar during the crossing of a subway shield tunnel underneath the bridge

Theoretical Analysis of Longitudinal Vertical Displacement of Subway Tunnels Caused by the Construction of Steel Casings for Bridge Piles

Dynamic Monitoring and Data Analysis of a Long-Span Arch Bridge Based on High-Rate GNSS-RTK Measurement Combining CF-CEEMD Method

Analysis for Ground Deformation Induced by Undercrossed Shield Tunnels at a Small Proximity Based on Equivalent Layer Method

Long-Term Monitoring and Safety Evaluation of A Metro Station During Deep Excavation

Monitoring and Analysis of the Impact of Adjacent Bridge Pile Construction on Subway Tunnels

Field Measurement Analysis of the Influence of Double Shield Tunnel Construction on Reinforced Bridge

An Improved Multi-Sensor MTI Time-Series Fusion Method to Monitor the Subsidence of Beijing Subway Network during the Past 15 Years

Investigation on the Influence of Active Underpinning Process on Bridge Substructures During Shield Tunnelling: Numerical Simulation and Field Monitoring

Integration of Multiband InSAR and Leveling Measurements for Analyzing the Surface Subsidence of Shield Tunneling at Beijing-Zhangzhou High-Speed Railway

Surface Deformation Time-Series Monitoring and Stability Analysis of Elevated Bridge Sites in a Coal Resource-Based City

Measurement Refinements of Ground-Based Radar Interferometry in Bridge Load Test Monitoring: Comprehensive Analysis on a Multi-Span Cable-Stayed Bridge

Newly Constructed Subway on Over-Track Bridge Safety and Vibration Reduction Measure

Structural Monitoring of Metro Infrastructure During Shield Tunneling Construction.

Data analysis and dynamic characteristic investigation of large-scale civil structures monitored by RTK-GNSS based on a hybrid filtering algorithm

Displacement Monitoring of a Bridge Based on BDS Measurement by CEEMDAN-Adaptive Threshold Wavelet Method

High-Precision Monitoring Method for Bridge Deformation Measurement and Error analysis Based on Terrestrial Laser Scanning

Strategy for vertical deformation of railway bridge monitoring using polarimetric ground-based real aperture radar system

Study on the Impact of Deep Foundation Excavation of Reclaimed Land on the Deformation of Adjacent Subway Tunnels

An automated health monitoring system for uncoordinated deformation between the metro station side wall and row piles

Monitoring Land Subsidence along the Subways in Shanghai on the Basis of Time-Series InSAR