Abstract:A through-feed rolling process with active rotation for manufacturing lead screw has been developed, where the speed matching and stable motion between workpiece and the rolling die during the whole rolling process can be ensured. Its process control, die structure and rolling equipment are relatively simple, and the accuracy of pitch for rolled lead screw can be effectively ensured. The motion characteristic during through-feed rolling process was analyzed, and then the general design criteria for the die were set up. The feasibility of the through-feed rolling process with active rotation was verified by experiment and finite element method (FEM). The verified results indicated that the error of lead-screw pitch between experimental value and designed value is about 0.125 %, and the error between the FEM value and the experimental and designed values is less than 1 %. According to the deformation characteristics of lead screw rolling and the distribution of field variables, the workpiece can be divided into non-deformation zone, entry-angle zone (incremental forming zone), correction zone, exit-angle zone, and full-formed zone. The same position of workpiece will undergo those five forming states in turn. The FEM results indicated that the effective stress and effective strain both gradually increase from the entry-angel zone to the correction zone, and the strain in the exit-angle zone and full-deformed zone are almost quite; the effective stress and effective strain in thread root are larger, and both gradually decrease along thread flank to thread crest; the distributions of stress and strain have a certain periodicity along the axial direction. The results in this study provide a basis for high-efficiency and precise rolling forming of threaded parts with large diameter such as the lead screw.

Study on hot rolling process of the D51 large-diameter threaded bars

Effect of Processing Technology on Mechanical Properties of HRB500 High-Strength Steel Bar Threading

Finite Element Analysis and Experiment Study on Axial Infeed Hot Rolling Process of Thread with Ti6Al4V

Numerical and experimental investigation on precision forming of ribbed tube by cold drawing process

The Importance of Forming Parameters on Rolling Process and the Performances of Component in Forming Long Threads

Experimental study on the surface defects of materials in bar rolling with a processing map applicable to billet-to-oval groove rolling

Study on near-net forming technology for bars by axial feed skew rolling based on taper-end billets

Modelling of the Rolling Process of Titanium Alloy Tube Billets in Laboratory Conditions on a RSP 14-40 Rolling Mill

Design of a multi-pass shaped roll drawing process for manufacturing square-shaped profiles

Analysis of Thread Rolling Process Using an Analytical Single Tooth Rolling Model Based on the Slip Line Field Theory and Slab Method

Process design and finite element analysis of multi-station two-roller cassette hot rolling for aluminum alloy 6061 wire

An innovative spinning-rolling process and its intelligent FE modelling for big-tapered profiled ring disk

Investigation and implementation for forming lead screw by through-feed rolling process with active rotation

Investigation of cold drawing process of thin-walled ribbed steel tube

Deformation Characteristics of Self-Infeed Rolling Process for Thread Shaft

Damage Initiation of 15V38 Steel Bar during Square‐to‐Round Hot Rolling Process

Influence of Cold-Rolling Processes on the Dimensional Accuracy and Roughness of Small-Diameter Thick-Walled Seamless Tubes

Numerical and Experimental Analysis of Deformation Behaviors and Microstructure Evolution in the Thread Rolling Process

Study on Roll Forming Process Simulation and Roll Diameters Optimization

Performance Improvement and Parameter Influence of Thread Shaft by Axial Self-infeed Rolling Process

Continuous Casting and Rolling for Aluminum Alloy Wire and Rod