Abstract:This research aims to complement and enhance the understanding of friction and wear behavior of AA7075 and CuZn39Pb2 under different conditions. One set of experiments were conducted under the laboratory conditions, simulating an ideal case using a ball-on-disc configuration, while the other set of experiments were conducted under the actual field conditions using a pin-on-disc configuration on a newly developed wear test bench. Effect of various tribological parameters such as load, sliding speed and wear track diameter was evaluated on the contact surface temperature, wear loss, wear rate and coefficient of friction. SEM analysis of worn surfaces and the wear track for each alloy were analyzed and compared. Results showed that different surfaces respond differently according to the type of wear test, the nature of material and the operating conditions. Even though, the error deviation in the wear rate calculations under both laboratory and actual field conditions does not exceed 10.75%, the results showed that the actual field conditions cannot be extrapolated from the ideal laboratory operating conditions. However, a comparative case study between an industrial setup and a lab setup shall definitely help in developing a better understanding of the wear behavior of materials by linking field conditions with that of the conditions in a laboratory. Moreover, results from an industrial setup can contribute to providing prototypes for solving industrial problems.

The Effect of Applied Load and Rotation Speed on Wear Characteristics of Al-Cu-Li Alloy

Wear Behaviour and Microstructural Changes of SiCw-Al Composite under Unlubricated Sliding Friction

Effect of Cold Deformation on Low Speed Sliding Wear of Al-10Ti Alloy

Tribological Behavior and Wear Mechanism of Cu-SiO2 Sintered Composite under Different Sliding Speeds

Influence of Cu content on mechanical and tribological properties of Al–7Si–Cu alloy

Effects of cold deformation on the low speed sliding wear of the RS/PM Al–10 wt.% Ti alloy against carbon steel

Dry Friction Characteristics of Ti-6Al-4V Alloy under High Sliding Velocity

Torsional Fretting and Torsional Sliding Wear Behaviors of CuNiAl Against 42crmo4 under Dry Condition

Friction and wear characteristics of aluminum bronze (QAl10-4-4) bearing materials under high-temperature dry sliding conditions

Dry Sliding Friction and Wear Behavior of CuZn39Pb2 and AA7075 Under Industrial and Laboratory Conditions

The Relationships Between Tribological Behaviour and Heat-Transfer Capability of Ti6Al4V Alloys

Research on Sliding Wear Behavior of Co-based Alloy Based on Experiments with Material of Pin and Disc Exchanged

Wear and Frictional Behavior of Copper Modified Ti-6Al-4V Alloy

Friction and wear behavior of CuFe3Al powder metallurgical composites in dry sliding

Sliding Friction and Wear Properties of GCr15 Steel under Different Lubrication Conditions

Correlation between the characteristics of the thermo-mechanical mixed layer and wear behaviour of Ti–6Al–4V alloy

A comparative study on torsional fretting and torsional sliding wear of CuNiAl under different lubricated conditions

Microstructural changes and dry sliding wear behavior of Cu-15Ni-8Sn-0.5Co alloy during deformation and aging treatment

Effect of Grain Size on the Tribological Behavior of CoCrFeMnNi High Entropy Alloy

Correlating numerical modelling with experimental studies to quantify the wear resistance of high-carbon chromium bearing steel in mixed lubrication

Microstructure and tribological behavior of a peak aged Cu–Cr–Zr alloy