Abstract:Massive high-strength concrete generates significant hydration heat during casting, which indirectly influences the risk of structural cracking by affecting the internal temperature gradient distribution. This paper investigated the effect of layered pouring methods on internal temperature gradients in massive concrete using the precast bent caps of a Shanghai bridge project as a case study. The temperature-time development patterns of each poured layer were studied through three sets of physical experiments. Temperature gradient distribution functions were established to specify the spatial temperature distribution trends of each layer. The interconnectedness between the spatial temperature distributions of adjacent poured layers was explored based on the established distribution functions. Targeted anticracking suggestions for layered poured concrete were provided based on these correlations. Additionally, a novel temperature control measure for managing hydration heat was proposed. The feasibility of this measure was verified through practical experiments. Moreover, corresponding finite element models were established to investigate the influence of parameters such as structural lead, outer wall pipe radius, and cooling water flow rate on the internal temperature field of concrete. The hydration heat-time patterns of the poured layers all showed a skewed single-peak distribution. The hydration heat of odd- and even-numbered layers exhibited different Gaussian distribution patterns in the lateral direction; the correlation between the spatial temperature distributions of adjacent layers could be quantified by the ratio of the standardized variance of the Gaussian distribution function of temperature for each corresponding layer. Implementing temperature control measures at specific reasonable positions and using a natural logarithmic function to calculate the design limits of structural dimensions could effectively prevent structural cracking. The newly proposed hydration heat control measure improved the temperature gradient distribution within the concrete. Reducing the structural lead, increasing the outer wall pipe radius, and increasing the cooling water flow rate all resulted in a decrease in the peak temperature inside the concrete. Finally, a structural lead of 0.4 was recommended for actual construction projects, for which the outer wall pipe radius should not exceed 30 mm.

Optimization of Temperature-Control Measures for Concrete Structures: A Case Study of the Sluice Project

Finite element analysis of temperature effect and crack-control measures for ultra-long concrete structures

Research And Application On Performance-Based Optimization Of Concrete Structure Construction

Investigation and Control of Cracks in Wet Joint of Concrete Box Girders

An Intelligent Cooling Control System for Mitigating the Cracking Risks of Mass Concretes During Bridge Construction

Temperature Control and Crack Prevention Measures for Concrete Ship Locks Subjected to Prolonged Casting Interruptions

Optimisation Study on Crack Resistance of Tunnel Lining Concrete Under High Ground Temperature Environment

Intelligent Cooling Control Method and System for Mass Concrete

Relationship between Ambient Temperature and Reasonable Heat Dissipation Coefficient of Mass Concrete Pouring Blocks

Control Measures for Preventing Crack on the Surface of Mass Concrete Abutment in Early Stage

Investigations of the hydration heat of large-volume precast concrete bent caps using layered pouring and a new temperature control measure

Early Age Properties and Cracking Control of Concrete

Numerical Analysis of Drying Shrinkage in Long Reinforced Concrete Structure

Crack control optimization of basement concrete structures using the Mask-RCNN and temperature effect analysis

Optimum selection of temperature control measures for combined intake tower in alpine region during construction period

Optimization Method for Improving Efficiency of Thermal Field Reconstruction in Concrete Dam

Research on Crack-Resisting Construction Design Method of Concrete Small Cavity Block Building Based on Temperature Effect

Feedback Design of Temperature Control Measures for Concrete Dams based on Real-Time Temperature Monitoring and Construction Process Simulation

Modeling and Mesoscale Simulation of Ice-Strengthened Mechanical Properties of Concrete at Low Temperatures

Temperature Control over Concrete Engineering for Works on Inner River of Changzhou Hydraulic Complex

Optimization of field test method on durability of coastal concrete structure