Abstract:External installation of steel braces is an effective approach to increase the lateral load resistance of steel moment-resisting frames. However, the effects of existence of steel braces on the robustness of steel moment-resisting frames to resist progressive collapse is still not clear because little study has been carried out. To fill this gap, in this paper, six multistory steel moment-resisting subframes (three bare frames and three braced frames) were fabricated and tested. Test results indicated that the specimen with reduced beam section in the connection zone performed best among three types of connections due to the guaranteed formation of plastic hinges at the location of reduced section and avoiding brittle fracture of weld at the connection. Experimental results proved that steel braces could increase the load-resisting capacity by 45.1% and 83.9% of the frame with weld connection and end plate connection, respectively. The gusset plate restricted the rotation of the plastic hinges in the second story of the braced frames with V-shaped bracing, which decreased its deformation capacity and degraded its catenary action capacity. Actually, the ultimate load of the braced frames with V-shaped bracing is only 87.5% of that of the counterpart without any braces. Because the compressive braces were severely buckled before the displacement reached 0.4% of the beam span, it had little effect on yield load but increased the initial stiffness of the bare frames. Thus, a majority of the benefits of the bracing system were attributed to the tensile braces. Moreover, the analytical results evaluated the differences in load resistance and development of load-resisting mechanisms in different stories. Furthermore, the contribution of compressive and tensile braces was decomposed individually by analytical analysis.

The influence of stretch wrap containment force on load bridging in unit loads

The anti-arch inhibition effect of multispan continuous girder bridge strengthened with prestressed CFRP plates

LATERAL RESISTANCE OF CHEVRON-BRACED FRAMES WITH WEAK BEAMS

Impact Behavior of Unbonded Post-Tensioned Concrete Beams

Influences of Wrinkles Induced by Tows’ Offset in Automated Fiber Placement on the Bending Properties of Composites

Influence of high-strength bolted end-plate connections in composite frames

Application of beam on elastic foundation to the interaction between a corrugated box and pallet deckboard

Effect of sustaining load level on flexural behavior of RC beams retrofitted with CFRP sheets

Behavior of Preloaded RC Beams Strengthened with CFRP Laminates

Influence of Effective Prestress on Ultimate Bearing Capacity for Large-Span Prestressed Concrete Bridge

Spatial Simulating Analysis Of Prestressing Force Effect Of Long Span Prestressed Concrete Box Girder Bridge

Postbuckling Analysis and Its Application to Stretchable Electronics

Effect of the Looseness of the Beam End Connection Used for the Pallet Racking Storage Systems, on the Mechanical Behavior of the Bearing Beams

The effect of tow gaps on compression after impact strength of robotically laminated structures

Effects of Steel Braces on Robustness of Steel Frames against Progressive Collapse

Vehicle Load Effect of Long-Span Bridges

RESEARCH ON PRACTICAL RESILIENCE MODEL OF LOAD VERSUS DISPLACEMENT FOR CONCRETE FILLED STEEL TUBULAR FRAME

Effect of Volume Tie Ratio in the Engineered Cementitious Composites Plastic Hinges on the Seismic Performance of RC Composite Bridge Columns

Influence by Bonding Styles of Prestressed Strands/Steels on Re-centering Behavior of PC Frames

Slab spatial composite effect in composite frame systems. I: Effective width for ultimate loading capacity

Effect of Preload Level on Flexural Load-carrying Capacity of RC Beams Strengthened by Externally Bonded FRP Sheets