Abstract:The objective of this work is to evaluate and optimize the screen‐printed front side metallization for silicon heterojunction (SHJ) solar cells. Three iterative experiments are conducted using different screen configurations and grid layout parameters. A batch of SHJ cells is metallized with an optimized front side grid layout using a knotless fine mesh screen, which results in a maximum efficiency gain of 0.17% and a decrease in silver paste laydown by ~2 mg. Within this work, we investigate the potential to optimize the screen‐printed front side metallization of silicon heterojunction (SHJ) solar cells. Three iterative experiments are conducted to evaluate the impact of the utilized fine mesh screen configurations and grid layout adaption (finger pitch) for the front side metallization on silver laydown and electrical performance of the solar cells. With respect to the screen configuration, we compare the performance of a fine‐mesh knotless screen to a conventionally angled screen demonstrating an additional gain of Δη = +0.1%abs due to reduced shading losses. Additionally, a grid layout is improved by increasing the number of contact fingers from 120 to 156. Furthermore, the current possibility to push the fine‐line printing process for low‐temperature pastes to the limit is investigated by reducing the nominal finger width wn to 20, 18, and 15 μm. It is shown that even the smallest nominal width of wn = 15 μm can be printed with high quality, leading to an additional efficiency gain of Δη = +0.15%abs as well as a reduction of silver paste laydown by −5 mg. Finally, a batch of champion cells is fabricated by applying the findings of the previous experiments, which results in a maximum efficiency of ηmax = 23.2%. Compared to the reference group without optimization, this corresponds to a gain of Δη = +0.17%abs, which comes along with an additional decrease of the silver paste laydown by approximately −2 mg. This emphasizes the significance of consistent optimization of the screen‐printing process in terms of cell performance and resource utilization for SHJ solar cells.

Interdigitated back contact silicon heterojunction solar cells: Towards an industrially applicable structuring method

Tuning of the Contact Properties for High-Efficiency Si/PEDOT:PSS Heterojunction Solar Cells

Optimized Metallization for Interdigitated Back Contact Silicon Heterojunction Solar Cells

Interdigitated back contact silicon heterojunction solar cell and the effect of front surface passivation

Simulation-based roadmap for the integration of poly-silicon on oxide contacts into screen-printed crystalline silicon solar cells

Silicon heterojunction back contact solar cells by laser patterning

Optimization of interdigitated back contact geometry in silicon heterojunction solar cell

Fast screen printing and curing process for silicon heterojunction solar cells

Both-Sided TOPCon Solar Cells – Towards a Lean Process Flow for Silicon Bottom Solar Cells

Development of TOPCon tunnel-IBC solar cells with screen-printed fire-through contacts by laser patterning

Evolutionary PERC+ solar cell efficiency projection towards 24% evaluating shadow-mask-deposited poly-Si fingers below the Ag front contact as next improvement step

Carrier-selective contacts for Si solar cells

Towards a cutting‐edge metallization process for silicon heterojunction solar cells with very low silver laydown

Post-Separation Processing for Silicon Heterojunction Half Solar Cells With Passivated Edges

A concept for Lithography-free patterning of silicon heterojunction back-contacted solar cells by laser processing

Improved Surface Passivation by Wet Texturing, Ozone‐Based Cleaning, and Plasma‐Enhanced Chemical Vapor Deposition Processes for High‐Efficiency Silicon Heterojunction Solar Cells

Silicon heterojunction solar cells with up to 26.81% efficiency achieved by electrically optimized nanocrystalline-silicon hole contact layers

Heterojunction and Passivated Contacts: A Simple Method to Extract Both n/tco and p/tco Contacts Resistivity

Surface Modification and Theoretical Investigation by Simulation for Light Trapping in Silicon Heterojunction Solar Cells

Intense Pulsed Light Meets the Metallization of Silicon Heterojunction Solar Cells