Abstract:Palladium has long been explored for use in gas sensors because of its excellent catalytic properties and its unique property of forming hydrides in the presence of H2. However, pure Pd-based sensors usually suffer from low response and a relatively high limit of detection. Palladium nanosheets (PdNS) are of particular interest for gas sensing applications due to their high surface area and excellent electrical conductivity. Here, we demonstrate the design and fabrication of low-cost PdNS-based dual gas sensors for room-temperature detection of H2 and CO over a wide concentration range. We fabricated sensors using multiwalled carbon nanotube@PdNS (MWCNT@PdNS) composites and compared their performance against pure PdNS devices for hydrogen sensing based on electrical resistive response. Devices using PdNS alone had a response and response time of 0.4% and 50 s, respectively, to 1% H2 in air. MWCNT@PdNS (1:5 mass ratio) showed enhanced performance at a lower hydrogen concentration with a limit of detection (LODH2) of 5 ppm. Nearly an order of magnitude increase in response was observed on increasing the amount of MWCNT to 50 mass % in the nanocomposite, but the response fell off at low H2 concentration. Overall, these PdNS-based sensors were found to show good repeatability, stability, and performance under humid conditions. Their response was selective for H2versus CH4, CO2, and NH3; the response to CO was comparable in magnitude but opposite in sign to the response to H2. Upon simultaneous exposure to equal concentrations (10 ppm each) of H2 and CO, the response to CO was dominant. The PdNS showed high sensitivity to CO, detecting as little as 1 ppm CO in air at room temperature. The sensitivity to CO could be used either in a stand-alone room-temperature CO detector, where H2 is known not to be present, or in combination with CO and combustible gas detectors to distinguish H2 from other combustible gases.

A High-Sensitivity Hydrogen Gas Sensor Based on Carbon Nanotubes Fabricated on Glass Substrate

Fabrication of Carbon-Nanotube Sheet Based Hydrogen Sensor

Room‐Temperature Hydrogen Sensor with High Sensitivity and Selectivity using Chemically Immobilized Monolayer Single‐Walled Carbon Nanotubes

Highly Sensitive Hydrogen Sensor Based on a New Suspended Structure of Cross-Stacked Multiwall Carbon Nanotube Sheet

Fabrication of Multiwall Carbon Nanotube Sheet Based Hydrogen Sensor on a Stacking Multi-Layer Structure.

Batch Fabrication of Ultrasensitive Carbon Nanotube Hydrogen Sensors with Sub-ppm Detection Limit.

Carbon Nanotube Films for Room Temperature Hydrogen Sensing

Carbon Nanotube Structured Hydrogen Sensors

An easy-fabricated hydrogen gas sensor based on palladium-decorated polyurethane nanofibers

A Room-temperature Hydrogen Gas Sensor Using Palladium-decorated Single-Walled Carbon Nanotube/Si Heterojunction

The distinguished hydrogen sensibility by selecting diameters of single-walled carbon nanotubes and adding sensitive materials

Highly Sensitive Detection of Hydrogen Gas Using Nanoporous Composites of Halloysite Nanotubes and Palladium

Resistive hydrogen sensors based on carbon nanotubes: A review

Transparent and Flexible Hydrogen Sensor Based on Semiconducting Single-Wall Carbon Nanotube Networks

High-temperature Hydrogen Sensor Based on Platinum Nanoparticle-Decorated SiC Nanowire Device

Hydrogen Sensors Based on Aligned Carbon Nanotubes in an Anodic Aluminum Oxide Template with Palladium As A Top Electrode

Sub-10 Parts Per Billion Detection of Hydrogen with Floating Gate Transistors Built on Semiconducting Carbon Nanotube Film

Uniformly dispersed Pt-Ni nanoparticles on nitrogen-doped carbon nanotubes for hydrogen sensing

Palladium Nanosheet-Based Dual Gas Sensors for Sensitive Room-Temperature Hydrogen and Carbon Monoxide Detection

The Detection of Hydrogen with A Nanotube Structured Sensor

Single-Walled Carbon Nanotubes Modified with Pd Nanoparticles: Unique Building Blocks for High-Performance, Flexible Hydrogen Sensors