Effect of Nano-Clay Particles and Heat Treating on Pure and Fretting Fatigue Properties of Piston Aluminum Alloy under Stress-Controlled Cyclic Bending Loading

Mohammad Sadegh Aghareb Parast,Mohammad Azadi

DOI: https://doi.org/10.1007/s11665-022-06658-y

IF: 2.3

2022-02-17

Journal of Materials Engineering and Performance

Abstract:In this article, the influence of the nano-clay particle and heat treating has been investigated on the pure and fretting fatigue properties of the piston aluminum alloys. The base studied material was cast AlSi12CuNiMg alloy. This material was reinforced by the addition of nanoparticles (1% of nano-clay) and the T6 heat treatment. The microstructures and morphological changes of phases were investigated by optical microscopy. Then, the pure fatigue and fretting fatigue tests were conducted at fully reversed stress-controlled cyclic bending loading through the high-cycle fatigue regime. Afterward, the fatigue and fracture behaviors of studied materials were examined by field emission scanning electron microscopy. Based on obtained results, however, the fatigue lifetime of the nano-composites reduced under the highest stress level, and the experimental data demonstrated that the fatigue properties of the nano-composite were improved by the heat treatment. In general, the fretting damage reduced the fatigue lifetime of all specimens. Under lower stress levels in the high-cycle fatigue regime, the lifetime reduction was more significant because of fretting damages. In addition, an epsilon-shaped trend was observed in the stress–lifetime curve extracted based on fretting fatigue averaged data. Testing results indicated that the nanoparticle and the heat treatment improved the material properties under fretting loading. Finally, the study of fracture surfaces indicated that all studied materials had brittle fracture behavior.

materials science, multidisciplinary