Abstract:The plastic deformation behavior of metal plates has been proved to be affected by loading paths. Plastic flow is a critical component in the mechanical description of plastic deformation, like yield and hardening. In this work, the anisotropic plastic flow of two metal plates (16MnCr5 and S420MC) under non-proportional loading conditions was investigated. Large specimens manufactured along different orientations were pre-tensioned up to various strain levels; subsequently, small uniaxial tensile specimens were cut from the pre-tensioned specimens along different orientations with the interval of 15°, and then loaded to rupture. Meanwhile, the r-value, a measure of anisotropic plastic flow, was recorded. Result shows that for the studied plates which had constant r-value in the monotonic uniaxial tensile tests, a downward evolution of the r-value against plastic strain was observed when the Schmitt angle of two stage loading directions was greater than 90°. As the plastic strain in the subsequent loading stage accumulated, the r-value dropped from a higher level to its original level within a strain range about 6.0%. Based on the transient r-value evolution, a HEXAH-based evolutionary plastic potential model was constructed within the framework of non-associated flow (non-AF) theory. In the model, a local ellipse-shape distortion of the plastic potential surface was defined during plastic deformation process and when the Schmitt angel exceeded 90°, such distortion caused a downward evolution of the r-value in the subsequent deformation. The calibration result indicates that the model could reproduce the transient r-value response relevant to loading path change. The proposed evolutionary plastic potential model can be applied together with different anisotropic hardening models in the non-AF theory to give a detailed description of the plastic deformation behavior and hopefully provide a solution for the accurate simulation of the complex sheet metal forming process.

Plastic Working of Metals

A Multi-Phase Model for Transformation Plasticity Using Thermodynamics-Based Metallurgical Algorithm

Plastic Deformation Behavior of Metal Materials: A Review of Constitutive Models

The Contribution of Severe Plastic Deformation to Research on Superplasticity

A Review on the Science of Plastic Deformation in Laser-Based Additively Manufactured Steel

Seventy-five years of superplasticity: historic developments and new opportunities

New Insight for Mechanical Properties of Metals Processed by Severe Plastic Deformation

Experimental and Modeling Investigation on Anisotropic Plastic Flow of Metal Plates under Nonproportional Loading Conditions

Fundamental research of welding plastic strain evolution process: Characteristics and law of evolution process of welding plastic strain in mild steel, stainless steel and titanium alloy thin plate

Recent development in the mechanics of superplasticity and its applications

Thermoplastic forming of amorphous metals

Advances in Superplasticity from a Laboratory Curiosity to the Development of a Superplastic Forming Industry

Recent Development of Superplasticity in Aluminum Alloys: A Review

New Solution for Plastic Deformation Process Intensification

Characterization and Failure Analysis of Plastics

Determining large-strain metal plasticity parameters using in-situ measurements of plastic flow past a wedge

Influence of heat treatments on plastic flow of laser deposited Inconel 718: Testing and microstructural based constitutive modeling

Methods of Accounting for Temperature and Strain Rate Variation in Multilevel Constitutive Models of Metal Deformation (Analytical Review)

Fundamental research of welded plastic strain evolution process II: Evolution process of welded plastic strain in thin stainless steel plate

Influence of the Plastic Deformation Process on the Residual Stresses and Hardness of an Al-5Mg Alloy

Plasticity-Induced Heating: Revisiting the Energy-Based Variational Model