Plasticity-Induced Heating: Revisiting the Energy-Based Variational Model

Christoph Hartmann,Michael Obermeyer

DOI: https://doi.org/10.3390/ma17051078

IF: 3.4

2024-02-27

Materials

Abstract:Temperature evolution during plastic deformation is of great importance for the design of manufacturing processes, as well as for the analysis and prediction of tool wear. However, the results from experimental- and numerical-type research are still often contradictory. In this paper, we analyze methods for estimating plasticity-induced heating directly from displacement fields that can be recorded during experiments or extracted from simulation results. In terms of computational methodology, the thermodynamically motivated energy-based variational formulation of the coupled thermo-mechanical boundary-value problem is adapted to the problem at hand. Since an analysis of this variational formulation exhibits challenges and distinct inconsistencies with respect to the problem at hand, an alternative approach is proposed. This alternative approach is essentially a purely thermal finite element simulation, and it is conducted using a heat source term that is empirically based on the fraction of irreversible deformation work converted to heat. Our approach estimates plasticity-induced heating based on the strain and strain rate data derived from displacement fields. We therefore incorporate thermo-visco-plastic constitutive behavior (Johnson–Cook) with a thermodynamically motivated model that specifies the fraction of plastic work converted to heat (the Taylor–Quinney coefficient).

materials science, multidisciplinary,chemistry, physical,physics, applied, condensed matter,metallurgy & metallurgical engineering

What problem does this paper attempt to address?

### Problems the Paper Attempts to Solve

This paper aims to address the issue of predicting temperature evolution during plastic deformation. Specifically, the focus is on how to directly estimate the heating caused by plastic deformation (i.e., plastic-induced heating) from displacement field data recorded in experiments or simulations. Currently, there are often contradictions between experimental and numerical research results, necessitating a more accurate method to predict and analyze temperature changes in tool wear and manufacturing process design.

### Key Points

1. **Background**:
- Temperature changes during the plastic deformation process are crucial for the design of manufacturing processes and the analysis and prediction of tool wear.
- Experimental and numerical research results often contradict each other, lacking consistency and accuracy.

2. **Method**:
- The authors analyzed methods to directly estimate plastic-induced heating from displacement field data recorded in experiments or simulations.
- An energy-based variational formulation was used to handle the coupled thermomechanical boundary value problem.
- An alternative method was proposed, using an empirical heat source term based on the proportion of irreversible deformation work converted to heat for pure thermal finite element simulations.

3. **Model**:
- Thermo-viscoplastic constitutive behavior (Johnson-Cook model) and thermodynamic motivation model (Taylor-Quinney coefficient) were introduced to estimate plastic-induced heating.
- The state potential energy and dissipation pseudo-potential were directly defined through the variational formulation, thus avoiding explicit assumptions of the Taylor-Quinney coefficient.

4. **Objective**:
- To adapt the variational model to given displacement field data and verify its effectiveness.
- To propose an alternative method to address the challenges and inconsistencies of the variational formulation in specific problems.

### Summary

The main goal of the paper is to solve the problem of predicting temperature evolution during plastic deformation by improving and validating an energy-based variational model. This not only helps to enhance the accuracy of manufacturing process design but also better analyzes and predicts tool wear.