Abstract:Direct Laser Writing (DLW) using ultrashort pulsed lasers and galvanometer scanning, has become an established process for surface texturing, allowing an extensive variety of feature geometries and texture designs to be produced. The minimum feature sizes that can be generated are however limited by factors such as the laser output power, beam diameter, beam wavelength and associated optics. To address the need to produce even smaller texture features, Direct Laser Interference Patterning (DLIP) has been developed, which utilises bespoke beam splitting and converging optics to produce periodic interference fringing and enabling surface textures in the micrometric size range to be produced. In this study, the texturing of cast iron cylinder liner segments using DLW and DLIP processes is explored, to assess their tribological performance in high efficiency internal combustion engines, such as for hybrid applications. To facilitate the designs of textures and to capture high resolution data on surface interactions at specific points in the combustion cycle, the segmentation of cylinder lines and piston rings is undertaken. The results of tribology tests covering combinations of high and low speeds and contact pressures, have shown that the mechanical honing of cylinder liners could potentially be replaced with the cleaner DLIP texturing as an alternative. Optimised texture designs using the DLW process achieved up to a 54 % reduction in kinematic friction between the piston ring and textured cylinder liner surfaces, compared with mechanically honed cylinder liner segments. These results have indicated that DLW texturing offers the best improvement in friction performance in the boundary and mixed lubrication regimes at higher contact pressures, at both lower and higher sliding speeds. The results also provide useful comparative data on the performance of meso and micrometric scale textures and how they can be best applied to cylinder liners.

Impact of laser surface texturing (LST) on the tribological characteristics of piston rings and cylinder liners – a review. Part 2: application of the process

Impact of laser surface texturing (LST) on the tribological characteristics of piston rings and cylinder liners – a review. Part 1: development of LST technology

Improving Tribological Performance of Mechanical Components by Laser Surface Texturing

State of the Art in Laser Surface Texturing

The friction of surface textured cylinder liner segments modified by Direct Laser Writing and Direct Laser Interference Patterning processes

Femtosecond Laser Texturing of Surfaces for Tribological Applications

Does laser surface texturing really have a negative impact on the fatigue lifetime of mechanical components?

LASER SURFACE TEXTURING TO IMPROVE THE TRIBOLOGICAL PROPERTIES OF Ti ALLOYS

Effects of Laser Surface Texturing and Lubrication on the Vibrational and Tribological Performance of Sliding Contact

Enhancement of Surface Properties Using Ultrashort-Pulsed-Laser Texturing: A Review

Tailored surface textures to increase friction—A review

Effect of Nanosecond Laser Texturization on Tribological Behavior of AISI 321 Stainless Steel

Experimental research on the frictional performance of real laser-textured cylinder liner under different lubrication conditions

Effects of different surface textures on tribological performances of the cylinder liner-piston ring: An experimental study

The Effect of Laser Texturing of Steel Surfaces on Film Lubriction Based on Stribeck Curves

Realizing the tribological feasibility of novel laser surface texturing techniques for cold spray kinetically metallized stainless steel

A review on preparation process and tribological performance of coatings for internal combustion engine piston ring

Surface Texturing of Cylinder Liners: A Review

Tribological roles of MoS2 and PTFE nano oils at the rolling/sliding point contacts: Conventional versus textured contacts

Design Methodology and Application of Surface Texture: A Review