Abstract:The use of synthesis gas (SYNGAS) from waste gasification has been pointed out as a key strategy to help the energy transition. However, SYNGAS’ low calorific power is considered a difficult obstacle to its technological use in internal combustion engines. To overcome this, a novel free-piston linear motor has been proposed to pave the way for the use of SYNGAS in the mobility sector. Surface texturing has vast potential to reduce friction losses in this system. This study utilizes a deterministic numerical model to investigate the mixed lubrication performance of a textured piston ring/cylinder liner conjunction in a free piston engine. The model considers the simultaneous solution of the lubrication and asperity contact problems at the roughness scale, including texturing features on the cylinder surface. The numerical model employs the Reynolds equation with mass-conserving cavitation to calculate the inter-asperity fluid pressure. The rough contact model utilizes the Hertz theory for elastic contact to calculate the contact pressure at each asperity between the piston liner surface and the admitted smooth and rigid ring surface. Surface texturing demonstrated remarkable effectiveness, particularly in the hydrodynamic lubrication regime, with a maximum friction reduction of 38.5% observed for an area coverage of 50%. This was accompanied by a notable shift in the transition from the boundary to the mixed lubrication regime. The textured surfaces exhibited consistent efficiency in reducing fluid pressure and shear stress as the coverage of the textured areas increased. The incorporation of dimples on these surfaces played a crucial role by augmenting the lubricant storage capacity while concurrently reducing the real shear and contact areas. This study offers valuable insights into the nuanced friction-reducing mechanisms of surface textures, illuminating their influence on the coefficient of friction and the formation of lubricant films across various lubrication regimes.

Impact of laser surface texturing (LST) on the tribological characteristics of piston rings and cylinder liners – a review. Part 1: development of LST technology

Impact of laser surface texturing (LST) on the tribological characteristics of piston rings and cylinder liners – a review. Part 2: application of the process

Experimental research on the frictional performance of real laser-textured cylinder liner under different lubrication conditions

The friction of surface textured cylinder liner segments modified by Direct Laser Writing and Direct Laser Interference Patterning processes

Piston ring–liner lubrication and tribological performance evaluation: A review

Improving Tribological Performance of Mechanical Components by Laser Surface Texturing

Effects of different surface textures on tribological performances of the cylinder liner-piston ring: An experimental study

Surface Texturing of Cylinder Liners: A Review

A review on preparation process and tribological performance of coatings for internal combustion engine piston ring

Does laser surface texturing really have a negative impact on the fatigue lifetime of mechanical components?

Combined experimental and simulative approach for friction loss optimization of DLC coated piston rings

Deterministic Simulation of Surface Textures for the Piston Ring/Cylinder Liner System in a Free Piston Linear Engine

Effects of Laser Surface Texturing and Lubrication on the Vibrational and Tribological Performance of Sliding Contact

State of the Art in Laser Surface Texturing

Tribological and Mechanical Performance of Coatings on Piston to Avoid Failure—A Review

Effects of the array modes of laser-textured micro-dimples on the tribological performance of cylinder liner–piston ring

Influence of Macro-Scale Cylinder Liner Partial Surface Texturing on the Tribological Behavior of Two-Stroke Marine Diesel Engine Piston Ring

Effects of Chevron Micro-Textures on Tribological and Lubricating Performance of Cylinder Block/Valve Plate Interface in Axial Piston Pumps

Tribological behaviors of laser textured surface under different lubrication conditions for rotary compressor

On the Transient Three-Dimensional Tribodynamics of Internal Combustion Engine Top Compression Ring

Surface Texturing for Low Friction Mechanical Components