Abstract:Polyvinyl butyral (PVB) as hydrophilic modification agent and polypropylene-g-maleic anhydride (PP-g-MAH) as a compatibilizer were blended with polypropylene (PP) in order to prepare hydrophilic PP/PVB hollow fiber membranes by melt-spinning and stretching(MS-S). The effect of PVB at different mass ratios on crystallization behavior and hydrophilicity of PP/PVB blends was investigated by differential scanning calorimeter(DSC) and water contact angle (WCA). The wide angle X-ray diffraction (WAXD) and small-angle X-ray scattering (SAXS) were used to analyze the effect of PVB at different mass ratios on the crystalline lamellar structure of PP/PVB hollow fiber after annealed. The pore dimensions and distribution of inner surface of PP/PVB hollow fiber membranes were measured using field emission scanning electron microscope (FESEM). In addition, the porosity and pure water flux of PP/PVB hollow fiber membranes were tested. The results showed that the hydrophilicity of PP/PVB blends was improved obviously because of WCA of PP/PVB blends reduced from 103 degrees to 76 degrees with the increase of PVB. At the same time, PVB accelerated the nucleation rate of PP because of PVB acted as heterogeneous nucleation effective. However, the maleic anhydride of PP-g-MAH was chemically bound to hydroxy of PVB, which also delayed the motion of molecular chain and leaded to imperfect crystal structure, especially excessive addition of PVB. The results confirmed WAXD and SAXS analysis. The crystallinity of PP/PVB2. 5 (2. 5% PVB) hollow fiber was better than that of pure PP hollow fiber after annealed. The lamellar orientation, lamellar thickness, and structure of Shish-Kebab of PP/PVB2. 5 hollow fiber were better than that of pure PP hollow fiber after annealed. The porosity of corresponding hollow fiber membrane was 66% and pure water flux was 320 L/(m(2) . h) , which increased by 76. 8% compared with that of the pure PP hollow fiber membrane.

Effects of Cooling Ways on the Structure of Polypropylene Hollow Fiber Membranes Prepared by Stretching

Structure formation and characterization of PVDF hollow fiber membranes by melt-spinning and stretching method

Preparation and Structural Control of Polyethylene Hollow Fiber Membranes

Effect of Coagulation Bath Temperature on the Structure and Performance of Polyethersulfone Hollow Fiber Membranes by Dry/wet Process

Effects of Annealing Stress Field on the Structure and Properties of Polypropylene Hollow Fiber Membranes Made by Stretching

Effect of Spin-Draw Rate and Stretching Ratio on Polypropylene Hollow Fiber Membrane Made by Melt-Spinning and Stretching Method

Effect of Tep Content in Cooling Bath on Porous Structure, Crystalline and Mechanical Properties of Pvdf Hollow Fiber Membranes

Effect of Hot Stretching on the Structure of Polypropylene Microporous Membranes with in Situ Small Angle X-Ray Scattering

Effects of Room Temperature Stretching and Annealing on the Crystallization Behavior and Performance of Polyvinylidene Fluoride Hollow Fiber Membranes

Preparation of Hydrophilic Polypropylene/Polyvinyl Butyral Hollow Fiber Membranes by Melt-spinning-stretching

Influence of Annealing Temperature on the Lamellar and Connecting Bridge Structure of Stretched Polypropylene Microporous Membrane

Effects of Spinning Temperature on Hollow Fiber Membrane Prepared Via Thermally Induced Phase Separation

Morphology and Formation Mechanism of Poly(Vinylidene Fluoride) Membranes Prepared with Immerse Precipitation: Effect of Dissolving Temperature

Fabrication of Microporous Membranes from Melt Extruded Polypropylene Precursor Films Via Stretching: Effect of Annealing

Experimental And Numerical Analyses On The Poly(Lactide-Co-Glycolide) Hollow Fiber Membranes

Effect of stretching on structure and properties of polyethylene hollow fiber membranes made by melt-spinning and stretching process

Effect of Dissolving Temperature of Dopes on the Morphology of PVDF Membrane

Effect Of Preparation Methods On Crystallization Behavior And Tensile Strength Of Poly(Vinylidene Fluoride) Membranes

In situ Small Angle X-ray Scattering Study on the Pore Formation Mechanism of Polypropylene Microporous Membranes Prepared by the Melt-stretching Method

Effect of Spinning Conditions on the Structure and Performance of Hydrophobic PVDF Hollow Fiber Membranes for Membrane Distillation

Effects of combined melt stretching and fast cooling fields on crystallization of high-density polyethylene