Abstract:Age hardening at 160 degrees C was performed in an Al-6.0 wt.%Zn-2.3 wt.%Mg-I.8 wt.%Cu-0.1 wt.%Zr alloy. It was found that metastable phases played a very important role in controlling this behaviour. The alloy reached the 193 HV peak hardness aged for 6 h. Transmission electron microscopy was used to characterise the morphology of iy phases as main strengthening precipitates, and then the high-resolution transmission electron microscopy, combining with Transition Matrix calculation, was used to analysis the orientations and electron diffraction patterns of eta' precipitates. It was found that the eta' phases in four variants had only three different zone axis: [2 (4) over bar 23](eta'), [10 (1) over bar0] T and [(2) over tilde4 (2) over bar3](eta'), parallel to the [110](Al) direction of Al matrix when they were precipitated. By integrating the atomic coordinates, structure factors and double diffraction effect, a new diffraction patterns model under the [110](Al) zone axis was established, which was good in agreement with the experimental result. Simultaneously, Moire fringes analytical technique was also used to quantitatively verify the lattice parameters and orientation variants of eta' precipitates, and demonstrated that Moire fringes with about 0.7 nm spacing were the results of the interaction between the 0004(eta')/4000 (4) over bar (eta'), diffraction eta' of Ti' precipitates in variants 3/4 under the [10 (1) over bar0] y zone axis and the 1 (1) over bar (Al)/1 (1) over bar(1) over bar (Al) of Al matrix under the [110](Al) zone axis. Furthermore, the high-resolution transmission electron microscopy image simulation for Moire fringes of eta' precipitates in the Al matrix presented a good match with the experimental result. (C) 2014 Elsevier B.V. All rights reserved.

Determination of the Parameters of Precipitates in Aged Mg – 8% Zn – 4% Al – 0.2% Cr – 0.5% Bi Alloy

Atomic-scale study on the precipitation behavior of an Al-Zn-Mg-Cu alloy during isochronal aging

Microstructure and Mechanical Properties of Mg-Xy-1.5mm-0.4zr Alloys

Precipitation and Its Effect on Age-Hardening Behavior of As-Cast Mg–Gd–Y Alloy

Characterization of precipitates in aged Mg-4 wt%Zn alloy

Small Angle X-Ray Scattering Study on Microstructure Evolution of the Aging Process of Al-Zn-Mg-Cu-Li Alloy

Effect of Ageing Temperature on Precipitation of Al-Cu-Li-Mn-Zr Alloy

Precipitation Microstructure and Age-Hardening Response of an Mg–Gd–Nd–Zn–Zr Alloy

Study on Aging Precipitation in Cu-Cr-Zr-Mg Alloy

Hardening Effect and Precipitation Evolution of an Isothermal Aged Mg-Sm Based Alloy

Quantitative Evaluation of Precipitates in an Al–Zn–Mg–Cu Alloy after Isothermal Aging

Characterization and Strengthening Effect of Precipitate Microstructure in Mg-3nd-3gd-0.2zn-0.5zr Alloy Aged at 225 °C

Research on aging precipitation in a Cu–Cr–Zr–Mg alloy

Microstructure, mechanical properties and fracture behavior of peak-aged Mg34Y32Nd31Gd alloys under different aging conditions

Structural examination of aging precipitation in a Mg-Y-Nd alloy at different temperatures

Precipitation Behaviour of Al–Zn–Mg–Cu Alloy and Diffraction Analysis from Η′ Precipitates in Four Variants

Effect of Ageing Treatment on the Precipitation Behaviour of Mg–Gd–Y–Zn–Zr Alloy

Aging hardening and precipitate behavior of a solution-treated Mg-6Zn-4Sn-1Mn (wt.%) wrought Mg alloy

Precipitation Sequence of an Aged Al-Mg-Si Alloy

Precipitation in a Mg–10Gd–3Y–0.4Zr (wt.%) Alloy During Isothermal Ageing at 250 °C

Microstructure evolution and performance of Mg-8Gd-3Y-1Nd-0.5Zr alloy during heat treatment