Abstract:This paper presents characterization and compensation of the thermal bias drift of a MEMS accelerometer whose effective stiffness is electrostatically tuned to a low value with the help of the single-sided parallel plates (SSPPs) capacitors. A temperature drift model for the proposed accelerometer is built and the temperature effect on the mechanical stiffness and the circuit gains is characterized. The characterization reveals that the variations of the feedforward coefficient including the mechanical stiffness and the readout gain due to the temperature change play a significant role in the bias drift of output of the proposed closed-loop accelerometer. On the other hand, the variations of both feedback gain and tuning gain as a function of temperature are one-order-of-magnitude less than that of the feedforward coefficient. To calibrate the feedforward coefficient, an excitation signal as a form of AC reference displacement is introduced to drive the proof mass and the readout response is demodulated to calibrate the variance of the feedforward coefficient correspondingly. An open-loop compensation scheme for the temperature-induced bias drift using the variance of the calibrated response is proposed accordingly. Alternatively, the calibrated response can be controlled to a preset value by a new proportion integral derivative (PID) controller by the adjustment of the SSPP tuning voltage. The output of the PID controller is used for the calibration of the introduced bias from the electrostatic tuning force. Therefore, a closed-loop compensation of the thermal bias drift is achieved by remaining the feedforward coefficient while eliminating the calibrated bias. Experiments under a temperature cooling process and different tuning voltages are carried out to verify two proposed compensation schemes. The temperature drift coefficients (TDCs) of both compensated outputs exhibit at least one-order-of-magnitude reduction in response to the temperature change. When the effective stiffness of the accelerometer is tuned to about 4.19 N m(-1), the TDC of the compensated output using the proposed open-loop or closed-loop compensation schemes is reduced to about 0.1136 or 0.0391 mg degrees C-1, respectively and meanwhile, the Allan bias instability is slightly increased to 48.63 or 56.14 mu g, respectively.

Study on Zero Drift of Charge Amplifier Based on MOSFET 3N165 and OPA LF356N

System Design of a Low Noise, Low Offset Instrumentation Amplifier with Chopper Stabilization

A Low Drift Curvature-Compensated Bandgap Reference with Trimming Resistive Circuit

A Controllable Resistor and Its Applications in Pole-Zero Tracking Frequency Compensation Methods for Ldos

Temperature Compensation Method for MEMS Accelerometer Based on Resonant Frequency

Characterization and Compensation of Thermal Bias Drift of a Stiffness-Tunable MEMS Accelerometer

Development of a Novel Strategy Based on In-Process Compensation of Charge Leakage for Static Force Measurement by Piezoelectric Force Sensors

Temperature Drift Compensation of a Tuned Low Stiffness MEMS Accelerometer Based on Double-Sided Parallel Plates

Control system for automated drift compensation of the stand-alone charge amplifier used for low-frequency measurement

Compensating Method of Zero Drift for Magneto-Sensing Torque Sensors

A Design of Miniaturized High Performance Charge Amplifier

A Novel Low Output Offset Voltage Charge Amplifier for Piezoelectric Sensors

A calibration method of the zero-drift for testing system of electronic transformer characteristics

Experimental investigation on zero drift effect in Coriolis mass flowmeters

A Zero-Offset Auto-Correction Circuit for Piezoresistive Micromachined Accelerometer

A 65 nm CMOS rail-to-rail auto-zero operational amplifier based on charge pump internal power supply

Design of a digital high accuracy power supply for piezoelectric ceramics

Charge Controller with a Novel Hysteresis Disturbance Observer for High-Accuracy Trajectory Tracking of Piezoelectric Actuators

A Charge Controller for Synchronous Linear Operation of Multiple Piezoelectric Actuators.

Linear Compensation to Thermal Bias Drift of MEMS Accelerometer Based on Temperature Measurement Circuit

Design of New Amplifier in Capacitive Accelerometer