Abstract:Finite element analysis is extensively used in the design of rubber products. Rubber products can suffer from large amounts of distortion under working conditions as they are nonlinearly elastic, isotropic, and incompressible materials. Working conditions can vary over a large distortion range, and relate directly to different distortion modes. Hyperelastic material models can describe the observed material behaviour. The goal of this investigation was to understand the stress and relegation fields around the tips of cracks in nearly incompressible, isotropic, hyperelastic accouterments, to directly reveal the uniaxial stress–strain relationship of hyperelastic soft accouterments. Numerical and factual trials showed that measurements of the stress–strain relationship could duly estimate values of nonlinear strain and stress for the neo-Hookean, Yeoh, and Arruda–Boyce hyperelastic material models. Numerical models were constructed using the finite element method. It was found that results concerning strains of 0–20% yielded curvatures that were nearly identical for both the neo-Hookean, and Arruda–Boyce models. We could also see that from the beginning of the test (0–5% strain), the curves produced from our experimental results, alongside those of the neo-Hookean and Arruda–Boyce models were identical. However, the experiment’s curves, alongside those of the Yeoh model, converged at a certain point (30% strain for Pieces No. 1 and 2, and 32% for Piece No. 3). The results showed that these finite element simulations were qualitatively in agreement with the actual experiments. We could also see that the Yeoh models performed better than the neo-Hookean model, and that the neo-Hookean model performed better than the Arruda–Boyce model.

Analysis and Research on Rubber Joint of the Axle Box Rotary Arm of CRH3 EMU

Analyzing Performance of Automobile Brake Drum in 3D Thermo-elastic Coupling Field

Elastic Finite Element Analyses and Experiment Research on Welded Spherical Joints with Square Hollow Sections

Experimental Characterization and Finite Element Modeling the Deformation Behavior of Rubbers with Geometry Defects

Research on Rolling Contact Fatigue Failure of the Bearing Used in High-Speed Electric Multiple Units’ Axle Box Based on a Damage-Coupled Elastic–Plastic Constitutive Model

Dynamic Characteristics Analysis of Axle Box Spring by FEM

Parameters Determination of Mooney-Rivlin Model for Rubber Material of Mechanical Elastic Wheel

Experimental study and modeling of rubber joints for railway vehicles using magnetorheological shear stiffening elastomers

A Visco-hyperelastic Constitutive Model for Rubber Considering the Strain Level and One Case Study in the Sealing Packer

Research on Variable Stiffness Bearing Capacity Characteristics of A New Intelligent Assembled Type Rubber Suspension System

Rigid-Elastic Coupling Modelling Of Air Suspension And Fatigue Life Prediction Of Its Key Part For Heavy-Duty Truck

Research on the Empirical Formulae of Rubber Cushion Stiffness

Investigating nonlinear dynamic properties of a swing arm rubber joint and their effects on the dynamic behavior of high-speed trains

Analysis on Influencing Factors of Lateral Stiffness of Mechanical Elastic Wheel

Analysis for complicated boundary constraint of rubber bushing on rear torsion beam

Comparison of two hyperelastic models for carbon black filled rubber

Reliability Assessment for Axle Box Spring of EMU Based on the Actual Operation Data

Experimental Research on Mechanical Properties of Stainless Steel Metal Rubber Elements for Damper Structure

Modeling Method of Constitutive Law of Rubber Hyperelasticity Based on Finite Element Simulations

The Uniaxial Stress–Strain Relationship of Hyperelastic Material Models of Rubber Cracks in the Platens of Papermaking Machines Based on Nonlinear Strain and Stress Measurements with the Finite Element Method

Research on Dynamic Load and Stress of High-speed EMU Motor Hanger Considering Influence of Gear Transmission System