Abstract:Lithium-ion batteries undergo structural deformation during operation because of the electrochemical-induced strain caused by the insertion of lithium ions inside the active material of the electrodes. In this work, the mechanical characteristic, i.e. thickness change, of batteries with different chemistries (lithium iron phosphate and lithium cobalt oxide) and formats (prismatic and pouch) is measured in-operando and with different current rates. A dedicated test bench is built to carry out the measurements with contactless triangulation optical sensors, sensing the displacement of the battery surfaces. The results are critically discussed, justifying the trajectory of the thickness change observed experimentally with the mechanical properties of the electrode's active materials. Furthermore, the results obtained with the batteries of different chemistries are compared, discussing the reasons underlying these differences. Statistical considerations on the results, such as repeatability errors and cell-to-cell differences, are provided as well. The mechanical characteristic appears as a three-stage linear curve, with two deflection points between the linear sections, and proportional to the state of charge of the battery. In fact, the mechanical characteristic tells the amount of lithium ions stored in each electrode, which together with the stoichiometric range defining the electrodes balancing, is closely related to the state of charge. Then, these measurements reveal an interesting tool for evaluating the state of charge. The two deflection points of the mechanical characteristic are linked to graphite stage changes. Then, these measurements carry the same information about battery degradation as the peaks in differential voltage analysis. The advantage is that the deflection points remain visible at any current rate, but the peaks in the differential voltage analysis vanish at high current rates. Then, these preliminary studies of the mechanical characteristic evidence it can become a promising alternative tool for evaluating the state of health as well.

Lithium-ion Battery Safety Tests monitored by LabVIEW and Comsol software for electrical and mechanical characteristics.

Experimental Analysis of Thermal Behavior of a Lithium-Ion Battery using Constant Voltage under Different Cooling Conditions

Development of Li-ion Battery Bulk Force and Expansion Displacement Test-bench

Li-ion Battery Simulation for Charging and Discharging using MATLAB Simulink

The electric-thermal coupling simulation and state estimation of lithium-ion battery

Virtual Testbed for Economical and Reliability Analysis of Battery Thermal Management Control Strategies

Analysis of Lithium-ion Batteries through Electrochemical Impedance Spectroscopy Modeling

Virtual Detection of Mechanically Induced Short Circuits in a Cylindrical Lithium-Ion Battery Cell Based on Finite Element Simulation

Lithium Battery Monitoring and Mathematically Modelling its Equation

Full-cycle electrochemical-thermal coupling analysis for commercial lithium-ion batteries

Study on Discharge Characteristic Performance of New Energy Electric Vehicle Batteries in Teaching Experiments of Safety Simulation under Different Operating Conditions

Physics-Informed Design of Hybrid Pulse Power Characterization Tests for Rechargeable Batteries

A high-fidelity lithium-ion battery emulator for electric vehicle application

Rapid Electrochemical Diagnosis of Battery Health and Safety from Cells to Modules

Open Hardware/Software Modular Battery Emulator for Battery Management Systems Development and Functional Testing

Mechanical characterization of lithium-ion batteries with different chemistries and formats

Review—Use of Impedance Spectroscopy for the Estimation of Li-ion Battery State of Charge, State of Health and Internal Temperature

Single point diagnosis of short circuit abuse condition in lithium‐ion battery through impedance data

Detection Technology for Battery Safety in Electric Vehicles: A Review

Expanded in situ aging indicators for lithium-ion batteries with a blended NMC-LMO electrode cycled at sub-ambient temperature

Comparative Testing of Li-Ion Battery Chemistries for Stationary Energy Storage