Abstract:The hazards associated with lithium-based battery chemistries are well-documented due to their catastrophic nature. Risk is typically qualitatively assessed through an engineering risk matrix. Within the matrix, potentially hazardous events are categorized and ranked in terms of severity and probability to provide situational awareness to decision makers and stakeholders. The stochastic nature of battery failures, particularly the lithium-ion chemistry, makes the probability axis of a matrix difficult to properly assess. Fortunately, characterization tools exist, such as accelerated rate calorimetry (ARC), that characterize degrees of battery failure severity. ARC has been used extensively to characterize reactive chemicals but can provide a new application to induce battery failures under safe, controlled experimental conditions and quantify critical safety parameters. Due to the robust nature of the extended volume calorimeter, cells may be safely taken to failure due to a variety of abuses: thermal (simple heating of cell), electrochemical (overcharge), electrical (external short circuit), or physical (crush or nail penetration). This article describes the procedures to prepare and instrument a commercial lithium-ion battery cell for failure in an ARC to collect valuable safety data: onset of thermal runaway, endotherm associated with polymer separator melting, pressure release during thermal runaway, gaseous collection for analytical characterization, maximum temperature of complete reaction, and visual observation of decomposition processes using a high temperature borescope (venting and cell can breach). A thermal "heat-wait-seek" method is used to induce cell failure, in which the battery is heated incrementally to a set point, then the instrument identifies heat generation from the battery. As heat generates a temperature rise in the battery, the calorimeter temperature follows this temperature rise, maintaining an adiabatic condition. Therefore, the cell does not exchange heat with the external environment, so all heat generation from the battery under failure is captured.

Rapid Electrochemical Diagnosis of Battery Health and Safety from Cells to Modules

Accelerated Commercial Battery Electrode-Level Degradation Diagnosis Via Only 11-Point Charging Segments

Battery safety: Fault diagnosis from laboratory to real world

Fast Diagnosis of Failure Mechanisms and Lifetime Prediction of Li Metal Batteries

Early Detection of Li-Ion Battery Thermal Runaway Using Commercial Diagnostic Technologies

Accelerating Rate Calorimetry and Complementary Techniques to Characterize Battery Safety Hazards

Rapid State of Health Estimation of Lithium-ion Batteries Based on an Active Acoustic Emission Sensing Method.

Non-destructive characterization techniques for battery performance and lifecycle assessment

Physics-Informed Design of Hybrid Pulse Power Characterization Tests for Rechargeable Batteries

A Fast Diagnostic to Inform Screening of Discarded or Retired Batteries

Challenges and needs for system-level electrochemical lithium-ion battery management and diagnostics

Accelerating Measurement Times by Correlating Electrode/Electrolyte Interface Properties with Cycle and Calendar Lifetimes

Electrochemical Impedance Spectroscopy: A New Chapter in the Fast and Accurate Estimation of the State of Health for Lithium-Ion Batteries

Rapid 3D Nondestructive Imaging Technology for Batteries: Photoacoustic Microscopy

Rapid online solid-state battery diagnostics with optically pumped magnetometers

Data-Driven Fault Diagnosis in Battery Systems Through Cross-Cell Monitoring

Physics-Informed Design of Hybrid Pulse Power Characterization (HPPC) Tests for Rechargeable Batteries

Probing Degradation in Lithium Ion Batteries With On‐Chip Electrochemistry Mass Spectrometry

In-situ electronics and communications for intelligent energy storage

Rapid online health estimation for lithium-ion batteries based on partial constant-voltage charging segment