Abstract:This paper reports the fatigue analysis for a failure of a shaft in a wind turbine in which reinforced-welding elbow to support the shaft load. The shaft was broken near the reinforcing elbow. When designing mechanical and structural components, the diameter and the characteristics of materials have been considered not to exceed the permissible limit. However, after 40 days of the cycle operation, the shaft was broken at the accepted loading conditions within reasonable limits at a wind speed of 6-10 m/s. The crack initiate fatigue in the shaft is influenced by many variables that may due to uniaxial, bending, torsion, the shape of loading curve, part size, part finish, operating temperature, and atmosphere. For these reasons, it is important to investigate the fatigue behavior on the failure of the shaft. The main goal is to investigate and analyze the fatigue behavior on a broken shaft of the wind turbine gearbox to determine the features that cause the failure. A microscopic investigation of the fatigue-fracture surface was done. The microscopic analysis was carried out in terms of the chemical composition using ARL Spark Spectrometer, energy dispersive spectroscopy (EDS), the morphology of the fatigue by using scanning electron microscopy (SEM) and hardness test. Moreover, a theoretical analysis was made to illustrate the results and comparison between these results and the corresponding stress distribution data from a finite element method (FEM) simulation to know how the fatigue fracture began and propagated along the shaft. The result of the analysis shows that the fatigue occurred due to the unbalanced of the bending and torsion stress in the junction of the reinforced-welding elbow with hardness testing at the extreme cracking area is 435 HV. It is emphasized that the microstructure of fatigue surface structure shows sensitization to facilitate intergranular cracking and fatigue corrosion.

Failure Analysis of a MW-Class Wind Turbine Blade Root Bolt

Microstructure Degradation of Service-Exposed Turbine Blades Made of Directionally Solidified DZ125 Superalloy

FEM Based Strength Verification of High Duty Bolts in MW Class Wind Turbine

Failure Analysis of High Strength Steel Bar Used in a Wind Turbine Foundation

Failure analysis of one main wheel hub bolt fracture of A320 aircraft

Failure Analysis of the Final Stage Blade in Steam Turbine

Fracture Analysis of a 135MW Steam Turbine's Last Stage Blade

Failure Analysis of Fixed Bolts in Tobacco Machinery Fixed Blade

Crack investigation of martensitic stainless steel turbine blade in thermal power plant

Fracture Failure Analysis on Bolt for Power Plant

Fatigue Failure Analysis of Shaft in As-developed Wind Turbine with Reinforced-welding Elbow

THE STRUCTURAL ANALYSIS METHOD OF WIND TURBINE BLADE BASED ON MECHANICS OF COMPOSITE MATERIALS

Failure Analysis of Ruptured Bolts in Coal Gas Heater

Fatigue Life and Strength Analysis of a Main Shaft-to-Hub Bolted Connection in a Wind Turbine

Failure Test and Finite Element Simulation of a Large Wind Turbine Composite Blade under Static Loading

An Investigation Of The Failure Of Low Pressure Steam Turbine Blades

Analysis of Fatigue Cracking for Turbine Blade

Structural Strength and Failure Prediction on FRP Laminate of Wind Turbine Blade

Fracture Analysis and Fatigue Strength Calculation of Anchor Bolt Used in Circulating Water Pump in Nuclear Power Plant

Progressive Failure Analysis for 5MW-Class Wind Turbine Composite Blades with Debonding Damage based on CZM Method

Failure analysis of a martensitic stainless steel steam turbine blade