Selective removal of Na+ by NaTi2(PO4)3-MWCNT composite hollow-fiber membrane electrode in capacitive deionization

Joosung Park,Mi-Young Lee,Seungyeob Han,Keun-Young Lee,Seoktae Kang,Joosung Park,Mi-Young Lee,Seungyeob Han,Keun-Young Lee,Seoktae Kang
DOI: https://doi.org/10.1038/s41545-022-00156-3
IF: 11.4
2022-04-19
npj Clean Water
Abstract:Abstract In this study, NaTi 2 (PO 4 ) 3 (NTP) nanoparticles were incorporated into a carbon nanotube hollow-fiber (CHF) electrode for the selective removal of Na + during the capacitive deionization (CDI) of salty water. Due to the Na + -selective electro-sorption of NTP nanoparticles, NTP-CHF achieved 1.5 ~2 times higher Na + adsorption capacity than that of CHF only electrodes at a range of 1.7 mM~17.1 mM (100 mg L −1 ~1000 mg L −1 ) NaCl solution. Moreover NTP-CHF sustained the Na + adsorption capacity even at the presence of Ca 2+ ions, whereas the dramatic decrease in Na + removal was observed in CHF with an increase of Ca 2+ concentration. As the result, NTP-CHF can retain 52% of the initial Na + removal capacity after three times of capture and release cycles at the presence of Ca 2+ , while CHF showed <10% of the initial Na + removal capacity due to the irreversible adsorption of Ca 2+ ions onto the MWCNT surface. Thus, the incorporation of NTP into the conductive carbon nanomaterial network can greatly improve both the adsorption capacity and selectivity of Na + compared to the conventional carbon-based electrode during the CDI of salty water containing multivalent cations such as Ca 2+ .
engineering, chemical,environmental sciences,water resources
What problem does this paper attempt to address?