Abstract:Although in many cases Pb isotopic analysis can be relied on for provenance determination of ancient bronzes, sometimes the use of “non-traditional” isotopic systems, such as those of Cu and Sn, is required. The work reported on in this paper aimed at revising the methodology for Cu and Sn isotope ratio measurements in archaeological bronzes via optimization of the analytical procedures in terms of sample pre-treatment, measurement protocol, precision, and analytical uncertainty. For Cu isotopic analysis, both Zn and Ni were investigated for their merit as internal standard (IS) relied on for mass bias correction. The use of Ni as IS seems to be the most robust approach as Ni is less prone to contamination, has a lower abundance in bronzes and an ionization potential similar to that of Cu, and provides slightly better reproducibility values when applied to NIST SRM 976 Cu isotopic reference material. The possibility of carrying out direct isotopic analysis without prior Cu isolation (with AG-MP-1 anion exchange resin) was investigated by analysis of CRM IARM 91D bronze reference material, synthetic solutions, and archaeological bronzes. Both procedures (Cu isolation/no Cu isolation) provide similar δ65Cu results with similar uncertainty budgets in all cases (±0.02–0.04 per mil in delta units, k = 2, n = 4). Direct isotopic analysis of Cu therefore seems feasible, without evidence of spectral interference or matrix-induced effect on the extent of mass bias. For Sn, a separation protocol relying on TRU-Spec anion exchange resin was optimized, providing a recovery close to 100 % without on-column fractionation. Cu was recovered quantitatively together with the bronze matrix with this isolation protocol. Isotopic analysis of this Cu fraction provides δ65Cu results similar to those obtained upon isolation using AG-MP-1 resin. This means that Cu and Sn isotopic analysis of bronze alloys can therefore be carried out after a single chromatographic separation using TRU-Spec resin. Tin isotopic analysis was performed relying on Sb as an internal standard used for mass bias correction. The reproducibility over a period of 1 month (n = 42) for the mass bias-corrected Sn isotope ratios is in the range of 0.06–0.16 per mil (2 s), for all the ratios monitored.

Correlation between lead isotope analysis and solid-state electrochemistry for determining the provenance of archaeological bronze

Lead isotope analysis for provenancing ancient materials: a comparison of approaches

Comparative Studies on Pb Isotope Ratios of Corrosion Rinds and Metal Cores of Bronze Vessels

Copper and tin isotopic analysis of ancient bronzes for archaeological investigation: development and validation of a suitable analytical methodology

Revisiting Lead Isotope Data in Shang and Western Zhou Bronzes

[The Application of Trace Element Analysis to the Study of Provenance of Copper Minerals in Ancient Bronzes].

MC ICP-MS Lead Isotope Analysis of Archaeological Metal Artifacts from the Bronze Age Sites of Eurasia

Mott–Schottky Analysis of Historical and Archaeological Copper–based Objects

Correlation between Voltammetry of Immobilized Particles and Mott‐Schottky analysis of metal corrosion patinas

The Feasibility of Lead Isotope Analyses for Provenance Study—comments on Qin Et Al “molding Experiment on Indicating Meaning of Lead Isotopes in Bronzes”

The Provenance of Yin-Shang Bronzes with Highly Radiogenic Lead Isotopes

High-Precision in Situ Analysis of the Lead Isotopic Composition in Copper Using Femtosecond Laser Ablation Mc-Icp-Ms and the Application in Ancient Coins

Characterization of corrosion products on contemporary bronze artwork by using voltammetry of microparticles and PCA

The identification of lead ingots from the Roman mines of Cartagena (Murcia, Spain): the role of lead isotope analysis

SIMS Analysis of Lead Isotope Composition in Ancient Chinese Metallic Artefacts

Lead Isotopes and Elemental Composition of Bronzes Excavated from Xiajiang Area of Chongqing, China Using MC-ICP-MS and SEM-EDS

Corrosion Behavior of Cu–Sn Bronze Alloys in Simulated Archeological Soil Media

Lead Isotopic Analyses of Copper Ores in the Early Bronze Age Central Hexi Corridor, North‐west China

Capabilities and limitations of Pb, Sr and Fe isotopic analysis of iron-rich slags: a case study on the medieval port at Hoeke (Belgium)

Early Stages of Metal Corrosion in Coastal Archaeological Sites: Effects of Chemical Composition in Silver and Copper Alloys

Corrosion Behaviour of Lead Bronze from the Western Zhou Dynasty in an Archaeological-Soil Medium