Abstract:Although in many cases Pb isotopic analysis can be relied on for provenance determination of ancient bronzes, sometimes the use of “non-traditional” isotopic systems, such as those of Cu and Sn, is required. The work reported on in this paper aimed at revising the methodology for Cu and Sn isotope ratio measurements in archaeological bronzes via optimization of the analytical procedures in terms of sample pre-treatment, measurement protocol, precision, and analytical uncertainty. For Cu isotopic analysis, both Zn and Ni were investigated for their merit as internal standard (IS) relied on for mass bias correction. The use of Ni as IS seems to be the most robust approach as Ni is less prone to contamination, has a lower abundance in bronzes and an ionization potential similar to that of Cu, and provides slightly better reproducibility values when applied to NIST SRM 976 Cu isotopic reference material. The possibility of carrying out direct isotopic analysis without prior Cu isolation (with AG-MP-1 anion exchange resin) was investigated by analysis of CRM IARM 91D bronze reference material, synthetic solutions, and archaeological bronzes. Both procedures (Cu isolation/no Cu isolation) provide similar δ65Cu results with similar uncertainty budgets in all cases (±0.02–0.04 per mil in delta units, k = 2, n = 4). Direct isotopic analysis of Cu therefore seems feasible, without evidence of spectral interference or matrix-induced effect on the extent of mass bias. For Sn, a separation protocol relying on TRU-Spec anion exchange resin was optimized, providing a recovery close to 100 % without on-column fractionation. Cu was recovered quantitatively together with the bronze matrix with this isolation protocol. Isotopic analysis of this Cu fraction provides δ65Cu results similar to those obtained upon isolation using AG-MP-1 resin. This means that Cu and Sn isotopic analysis of bronze alloys can therefore be carried out after a single chromatographic separation using TRU-Spec resin. Tin isotopic analysis was performed relying on Sb as an internal standard used for mass bias correction. The reproducibility over a period of 1 month (n = 42) for the mass bias-corrected Sn isotope ratios is in the range of 0.06–0.16 per mil (2 s), for all the ratios monitored.

Feasibility studies of Sn isotope composition for provenancing ancient bronzes

Copper and tin isotopic analysis of ancient bronzes for archaeological investigation: development and validation of a suitable analytical methodology

The tin content of lead inclusions in ancient tin‐bronze artifacts: a time‐dependent process?

Revisiting Trace Element Data and Metal Circulation Investigation of Western Zhou Bronzes

Provenance of the Material for Bronze Vessels of the Shang and Zhou Dynasties unearthed from Some Areas of China

Provenance-tracking of Bronze Vessel Using Rare Earth Elements in Clay Mould Residues

Provenancing Copper in the Middle Shang Period Through Isotopic Analysis of Metallurgical Remains

Development of a multi-isotopic (Pb, Fe, Cu) analytical protocol in gold matrices for ancient coin provenance studies

Equilibrium Sn Isotope Fractionation among Sn-Bearing Minerals

Accurate determination of stable silver isotopes in zinc-rich samples through effective separation of silver and zinc

Scientific analysis on the Han bronze wares unearthed from Xiangyang, Hubei Province, China

Revisiting the Addition of Tin and Lead in Chinese Bronzes: A Statistical Perspective

Isotopic Investigations of Chinese Ceramics

Correlation between lead isotope analysis and solid-state electrochemistry for determining the provenance of archaeological bronze

Lead Isotope Ratio Analysis of Lead Ingots and Bronze Wares Unearthed from Yinxu

Osmium isotope analysis as an innovative tool for provenancing ancient iron: A systematic approach

A Preliminary Study on Silver Isotopic Composition in Polymetallic Ore Deposits in Eastern China

Two Sides of the Same Coin: A Combination of Archaeometallurgy and Environmental Archaeology to Re-Examine the Hypothesis of Yunnan as the Source of Highly Radiogenic Lead in Early Dynastic China

Tin Isotope Heterogeneity and Baseline of the Upper Continental Crust

A Pb-free Sn–Bi alloy mount preparation method for secondary ion mass spectrometry (SIMS) analyses

Archaeometallurgical study of bronze slags from the Yangqiaopan ancient city site in Northern Shaanxi, China