Abstract:This article presents a comprehensive thermomechanical analysis and failure assessment in the drilling of glass fiber-reinforced polymer (GFRP) composites with different thicknesses using a CNC machine and cemented carbide drill with a diameter of 6 mm and point angles of ϕ = 118°. The temperature distribution through drilling was measured using two techniques. The first technique was based on contactless measurements using an IR Fluke camera. The second was based on contact measurements using two thermocouples inserted inside the drill bit. A Kistler dynamometer was used to measure the cutting forces. The delamination factors at the hole exit and hole entry were quantified by using the image processing technique. Multi-variable regression analysis and surface plots were performed to illustrate the significant coefficients and contribution of the machining variables (i.e., feed, speed, and laminate thickness) on machinability parameters (i.e., the thrust force, torque, temperatures, and delamination). It is concluded that the cutting time, as a function of machining variables, has significant control over the induced temperature and, thus, the force, torque, and delamination factor in drilling GFRP composites. The maximum temperature recorded by the IR camera is lower than that of the instrumented drill because the IR camera cannot directly measure the tool-work interaction zone during the drilling process. At the same cutting condition, it is observed that by increasing the thickness of the specimen, the temperature increased. Increasing the thickness from 2.6 to 7.7 had a significant effect on the heat distribution of the HAZ. At a smaller thickness, increasing the cutting speed from 400 to 1600 rpm decreased the maximum thrust force by 15%. The push-out delaminations of the GFRP laminate were accompanied by edge chipping, spalling, and uncut fibers, which were higher than those of the peel-up delaminations.

Analysis of exit-ply temperature characteristics and their effects on occurrence of exit-ply damages during UD CFRP drilling

A Study on Drilling High-Strength CFRP Laminates: Frictional Heat and Cutting Temperature

A Study on the Effect of Cutting Temperature on CFRP Hole Wall Damage in Continuous Drilling Process

Investigation of CFRP damages induced by the interface high temperature and mixed tool wear mechanism in drilling of thin-walled CFRP /Ti stacks

Analysis of high temperature and mixed tool wear effects on UD-CFRP cutting mechanism in stacks drilling

Influence of the Temperature-Dependent Characteristics of CFRP Mechanical Properties on the Critical Axial Force of Drilling Delamination

Optimized selection of process parameters based on reasonable control of axial force and hole-exit temperature in drilling of CFRP

Formation mechanism of outlet damage in interlaminar drilling of CFRP

Numerical study on the heat effect on the drilling damage of Ti/CFRP stacks

Investigation of high temperature effect on CFRP cutting mechanism based on a temperature controlled orthogonal cutting experiment

Heat-Affected Zone and Mechanical Analysis of GFRP Composites with Different Thicknesses in Drilling Processes

Analytical study of delamination damage and delamination-free drilling method of CFRP composite

Investigating the Effect of Low-Temperature Drilling Process on the Mechanical Behavior of CFRP

A Study on Drilling of CFRP/Ti Stacks: Temperature Field and Thermal Damage of the Interface Region

Study on exit damage characteristics of ultrasonic vibration assisted drilling of CFRP

Effects of machining conditions on the hole wall delamination in both conventional and ultrasonic-assisted CFRP drilling

Impact responses and residual flexural properties of narrow CFRP laminates

Thermo-Mechanical and Delamination Properties in Drilling GFRP Composites by Various Drill Angles

Research on prediction method of mechanical properties of open-hole laminated plain woven CFRP composites considering drilling-induced delamination damage

Carbon fiber reinforced polymer in drilling: From damage mechanisms to suppression

Damage formation and evolution mechanisms in drilling CFRP with prefabricated delamination defects: Simulation and experimentation