Abstract:CFRP (Carbon Fiber Reinforced Polymer) is widely used in the aerospace, automobile and construction industries. Its non-homogeneous and anisotropic nature often results in unfavorable hole quality during the drilling process, and exit delamination is a resulting phenomenon that has received much attention. Exit delamination occurs when the drilling thrust force exceeds the critical thrust force. It adversely affects product quality and may even result in rejection. The thrust force on the chisel edge is an important component of the total thrust force, and it helps to predict the total thrust force so that delamination can be reduced or avoided. In this study, noticing that the chisel edge has a certain length, the author puts forward the novel concept of the azimuth angle on the basis of the micro analysis of the contact state between the chisel edge and the carbon fiber. In addition to the orientation angle of the carbon fiber, the azimuth angle of the cutting edge is also an important factor that affects the thrust force. A single carbon fiber may be modeled as a beam on an elastic foundation, and the prediction model of thrust force on the chisel edge is established based on the theory of bending fracture. The model can reflect the influence of the material properties, cutting tool geometry parameters (including the length of chisel edge, rake angle and blunt radius of cutting edge), drilling process parameters, and ultrasonic vibration parameters on the thrust force on the chisel edge and quantitatively explain the reduction of thrust force and improvement of drilling quality during the longitudinal ultrasonic vibration drilling. The prediction model of the thrust force presented in this work can make up for the shortages of qualitative interpretation. The law of periodic variation of the chisel edge thrust force with the azimuth angle helps in developing a deep understanding of the CFRP drilling process and the material removal mechanism. The basis is provided in order to reduce and avoid the exit delamination defects in drilling, and to reasonably and quantitatively determine the spindle speed, feed rate, and drill bit geometry parameters. The reliability of the prediction model is verified by a drilling test.

Formation mechanism of outlet damage in interlaminar drilling of CFRP

Damage formation and evolution mechanisms in drilling CFRP with prefabricated delamination defects: Simulation and experimentation

Formation mechanism of CFRP pipe concave drilling defects

Carbon fiber reinforced polymer in drilling: From damage mechanisms to suppression

Optimized selection of process parameters based on reasonable control of axial force and hole-exit temperature in drilling of CFRP

Novel fiber fracture criteria for revealing forming mechanisms of burrs and cracking at hole-exit in drilling Carbon Fiber Reinforced Plastic

A review on CFRP drilling: fundamental mechanisms, damage issues, and approaches toward high-quality drilling

Determination of the optimal feed rate for step drill bit drilling CFRP pipe based on exit damage analysis

Mechanics of thrust force on chisel edge in carbon fiber reinforced polymer (CFRP) drilling based on bending failure theory

Improving hole quality of thick CFRP laminates through a laser-mechanical compound drilling process

A study on the ultrasonic vibration on the cutting performance during ultrasonic-assisted drilling of CFRP with twist and dagger drill bits

Investigation of CFRP damages induced by the interface high temperature and mixed tool wear mechanism in drilling of thin-walled CFRP /Ti stacks

Hole quality in longitudinal–torsional coupled ultrasonic vibration assisted drilling of carbon fiber reinforced plastics

Effects of machining conditions on the hole wall delamination in both conventional and ultrasonic-assisted CFRP drilling

Analytical study of delamination damage and delamination-free drilling method of CFRP composite

Effects of fiber orientations on fracture mechanisms in rotary ultrasonic drilling of carbon fiber reinforced plastic laminates

Analysis of exit-ply temperature characteristics and their effects on occurrence of exit-ply damages during UD CFRP drilling

A Study on Drilling High-Strength CFRP Laminates: Frictional Heat and Cutting Temperature

High reliability model of mechanical response in drilling of CFRP/Al stacks

Drill bit with clip-edges based on the force control model for reducing the CFRP damage

Damage mechanism of carbon fiber reinforced plastic pipe based on reverse and forward curvature drilling