Abstract:This study investigates the effects of pores in the reactant compact on the microstructure, fracture toughness, and thermal conductivity of sintered Si3N4 ceramics. The results showed that the pores in the compacts before sintering could improve the thermal conductivity and fracture toughness if they disappeared and promoted grain growth during the sintering procedure. Large silicon nitride (Si3N4) grain can enhance thermal conductivity and fracture toughness in the Si3N4 ceramics. In this study, in order to use pores as a grain growth trigger and to achieve final densification, a limited amount of pores were introduced into the green compact. The pores were introduced by using four types of pore formers with diameters of 2, 20, 30, and 100 μm, and the pore volume was in the range of 3–18 vol%. The presence of pores promoted grain growth regardless of their diameter and volume, because no collisions occurred among the grains in the pores, and larger pores formed larger elongated grains. However, their large volume and diameter inhibited densification. Based on this tradeoff, the pore formers with a diameter of 30 μm exhibited superior properties, and fracture toughness and thermal conductivity increased to 10.2 MPa·m1/2 and 118.2 W/(m·K), respectively, as the pore volume increased to 5 vol%. These results revealed that the pores in the compacts before sintering could improve the thermal conductivity and fracture toughness if they promoted grain growth during the sintering procedure and finally disappeared.

Pore structure, porosity and compressive strength of highly porous reaction-bonded silicon nitride ceramics with various grain morphologies

Microstructure and Mechanical Properties of Silicon Nitride Ceramics with Controlled Porosity

Optimization of Microstructure to Improve Si3n4 Ceramics with Thermal Conductivity and Mechanical Properties: Effect of Si and Α-Si3n4 Powder Composition

Porous silicon nitride and SiAlON ceramics: Fabrication and characterization

Simultaneous improvement in porosity and strength of porous β-Si3N4 ceramics by formation of ultrafine fibrous grains

Processing strategy to trigger grain growth in silicon nitride

Microstructure, Mechanical and Dielectric Properties of Highly Porous Silicon Nitride Ceramics Produced by a New Water-Based Freeze Casting

Fracture Behavior of Porous Si3n4 Ceramics with Random and Aligned Microstructure

Preparation of Porous Si3N4 Ceramics with Controlled Porosity and Microstructure by Fibrous Α‐si3n4 Addition

Microstructure Control and Mechanical Properties of Porous Silicon Nitride Ceramics

Effects of pore morphology on the fabrication and mechanical properties of porous Si3N4 ceramics

Synthesis and Mechanical Properties of Highly Porous Ultrafine-Grain Si3N4 Ceramics Via Carbothermal Reduction-Nitridation Combined with Liquid Phase Sintering

Fabrication of High-Porosity Silicon Nitride Ceramics with Excellent Mechanical Properties

Effect of Sintering Additives on Microstructure and Mechanical Properties of Porous Silicon Nitride Ceramics

Porous Silicon Nitride Ceramics Prepared by Reduction-Nitridation of Silica

Comparison of Mechanical Properties of Silicon Nitrides with Controlled Porosities Produced by Different Fabrication Routes

Fabrication of Porous Silicon Nitride Ceramics with Gradient Microstructure

Effects of Nitrogen Pressure on Microstructure and Mechanical Performance of Porous Silicon Nitride Ceramics

Biomimetic Synthesis of Porous Si_3N_4 Ceramics

Effects of Pore Morphology on the Fabrication and Mechanical Properties of Porous Si<sub>3</sub>N<sub>4</sub> Ceramics

Preparation And Properties Of High Strength Porous Si3n4 Ceramics