Abstract:Microwave processing has gained remarkable recognition based upon volumetric processing that is energy efficient. Susceptor-assisted microwave heating is a fast-emerging technology because of its advantages over traditional microwave processing. Susceptor help to speed up microwave processing by offering two-way heating with less heat loss from the material's surface. The present investigation brings out ways (theoretical, simulation and experimental) to select appropriate susceptor material by considering different types of microwaves absorbing material (alumina, yttria stabilized zirconia, boron nitride and silicon carbide) for efficient microwave heating. Theoretical analysis (dielectric properties, penetration depth, absorption loss and reflection loss) suggests silicon carbide (SiC) to be the most suitable susceptor. COMSOL Multiphysics based simulation in conjunction with experimental results were utilized for critical understanding of SiC susceptor heating. The influence of physical parameters: microwave input power, microwave frequency, placement of susceptor inside cavity and dimension of susceptor on electric field distribution and temperature profile of SiC susceptor are also investigated and presented in detail. Among all susceptor materials, SiC exhibited highest heating rate in similar operating parameters. The temperature obtained for SiC susceptor during microwave heating without casket (80 °C) was significantly lower than that with casket insulation (1003 °C). A susceptor of 10 mm thickness with cross-section of 625 mm2 was found to be the optimum dimension for SiC susceptor. The maximum temperature obtained by the SiC susceptor was 658 °C, 1003 °C, 1182 °C and 1380 °C for input power of 800 W, 1200 W, 1600 W and 2000 W respectively. Simulation data were validated with experimental results. The results exhibit a good agreement between simulation results and experimental data.

MICROWAVE RAPID HEATING SYSTEM USING CARBON HEATING TUBE

Efficient heating with a controlled microwave field.

Microwave heating of carbon materials for on-demand thermal patterning via tunable electromagnetic resonators

Thermal Management for Purification of Aligned Arrays of Single-Walled Carbon Nanotubes Based on Thermocapillary Flow by Pulsed Heating

Microwave Purification of Large-Area Horizontally Aligned Arrays of Single-Walled Carbon Nanotubes

Microheater Chips with Carbon Nanotube Resistors

Optical Microscopy inside a Heating Capillary

Heating Behavior And Crystal Growth Mechanism In Microwave Field

Three-dimensional Simulation of a Novel Microwave-Assisted Heating Device for Methyl Ricinoleate Pyrolysis

The Experiment of Thickness Relationship on Ceramic Fiberboard and Silicon Carbide to Temperature Rise in Microwave Oven for Sintering Hydroxyapatite

Compact Microwave Continuous-Flow Heater

Susceptor based design strategies for enhancing microwave hybrid heating capability via experimental analysis, 3D multi-physics simulation and parametric optimization

A New Method Used to Control the Structure of High Rate Microcrystalline Silicon Thin Films

Experimental and Computational Investigation of Heat Transfer in a Microwave-Assisted Flow System

Study on a Low Power and High Efficiency Micro Heater Used in Μpcr Chip

High-efficiency and compact microwave heating system for liquid in a mug

Effect of microwave annealing on amorphous Si of carbon powder

Instantaneous formation of metal and metal oxide nanoparticles on carbon nanotubes and graphene via solvent-free microwave heating

Mechanism analysis using multi-physical field coupling: Silicon carbide-assisted microwave heating of UMT-coated soil

Microwave heating and mechanism for seed-induced synthesis of SiC

Microwave-crystallization of Amorphous Silicon Film Using Carbon-Overcoat As Susceptor