Abstract:A series of hydrocracking catalysts based on mesoporous molecular sieves of MCM-41 and SBA-15 with different silica to alumina ratios was prepared. Nickel and molybdenum were used as active metals to impregnate the extrudates prepared by using molecular sieves. The catalysts were characterized for physical and chemical properties and evaluated for the hydrocraking of desulfurised vacuum gas oil. The conversion of DS-VGO was lower as compared to that of the catalyst based on USY zeolite. However, the gas yield was lower in case of mesoporous materials based catalysts. Introduction Zeolites are widely used as catalysts in petroleum refining and for the production of petrochemicals and fine chemicals. Recently, the breakthrough discovery of the M41S family mesoporous materials [1,2] exemplified by the MCM-41 bearing hexagonal-close-packed channels. Despite the excellent structural properties, the hydrothermal stability of MCM-41 and MCM-41-like mesoporous materials was reported as lower than their counter part zeolites. Recently, a new kind of mesoporous silica, SBA-15, has been synthesized with poly (alkylene oxide) triblock copolymers such as poly (ethylene oxide)-poly (propylene oxide)poly (ethylene oxide) (PEO-PPO-PEO) [3]. Beside its uniform and large pore size channels (4.6-30 nm), SBA-15 possesses thick walls (3.1-6.4 nm). Therefore, it has much higher hydrothermal stability than MCM-41 [3]. Owing to their extremely large surface area (generally exceeding 1000 mg) and ultra large pore size these mesoporous materials have attracted great practical and academic interest as acid-catalyzed reactions of large molecules such as hydroprocessing of residual oil [4-5]. In this study, the preparation of MCM-41 and SBA-15 with Si/Al 10, 20 and hydrocracking catalysts based on these mesoporous materials along with USY zeolite are presented. Commercial USY zeolite used in this study also has mesopores in it. Nickel and molybdenum are impregnated as active metals. Mesoporous materials and hydrocracking catalysts prepared were characterized by XRD, surface are, pore volume, pore-size distribution, particle size measurement, and acidity measurement by FTIR and ammonia TPD. The side crushing strength of the extrudates with alumina binder was also measured by crushing strength tester. The catalysts were evaluated for hydrocracking of desulfurized vacuum gas oil (DS-VGO). The hydrocracking activity was measured by GC-SIMDIST method and sulfur and nitrogen contents of the product were measured by elemental analyzer.

Catalyzing the Hydrocracking of Low Density Polyethylene

Mechanistic Understanding of Efficient Polyethylene Hydrocracking over Two-Dimensional Platinum-Anchored Tungsten Trioxide.

Enhanced hydroconversion of polyethylene via dual-functional catalysis: Exploiting ZSM-22 pore-mouth catalysis and Ru electronic effect

Catalytic Cracking of Polystyrene and Low-Density Polyethylene over Synthesized Zeolite Na-A with Optimized Crystallinity

Hydrocracking of Bio-Alkanes over Pt/Al-MCM-41 Mesoporous Molecular Sieves for Bio-Jet Fuel Production

Tuning High-Density Polyethylene Hydrocracking through Mordenite Zeolite Crystal Engineering

Catalyst Accessibility and Acidity in the Hydrocracking of HDPE: A Comparative Study of H-USY, H-ZSM-5, and MCM-41 Modified with Ga and Al

Elucidating the structure-performance relationship of typical commercial zeolites in catalytic cracking of low-density polyethylene

Ultra‐Narrow Alkane Product Distribution in Polyethylene Waste Hydrocracking by Zeolite Micropore Diffusion Optimization

Efficient Pyrolysis of Low-Density Polyethylene for Regulatable Oil and Gas Products by ZSM-5, HY and MCM-41 Catalysts

Catalytic Hydrogenolysis of Plastic to Liquid Hydrocarbons over a Nickel-Based Catalyst

Assessment of acidity and the zeolite porous structure on hydrocracking of HDPE

Conversion of polyethylene waste to short chain hydrocarbons under mild temperature and hydrogen pressure with metal-free and metal-loaded MFI zeolites

Hydroisomerization of n-hexadecane under mesoporous molecular sieve Pt/Al-SBA-15

Selective Hydrogenolysis Conversion of Polyethylene into Alkyl Oil over Iridium-based Catalyst

Synthesis and Catalytic Evaluation of Mesoporous Molecular Sieve Supported Hydrocracking Catalysts

Efficient Hydrocracking of Waste Polyethylene into Branched Liquid Fuels over Low Pt‐loaded Nb2O5 Catalyst

Synergetic Regulation of the Microstructure and Acidity of HZSM-5/MCM-41 for Efficient Catalytic Cracking of n-Decane

Opening up ZSM-5 Hierarchical Zeolite's Porosity through Sequential Treatments for Improved Low-Density Polyethylene Cracking

Hierarchical FAU Zeolites Boosting the Hydrocracking of Polyolefin Waste into Liquid Fuels

Catalytic reforming of polyethylene pyrolysis vapors to naphtha range hydrocarbons with low aromatic content over a high silica ZSM-5 zeolite