Abstract:RAFT polymerization is a type of psudo-living radical polymerization. In order to synthesize high pure block copolymers by RAFT polymerization, it is desirable to suppress the irreversible termination which may result in the formation of dead chains. For polymers less than 5 x 10(4) g/mol, the dead chain fraction could remain to be lower than 0.1 by reducing the initiator concentration. In the synthesis of block copolymers, the dead chains formed in the first stage are actually contaminant. Targeting to the synthesis of high pure block copolymers with high molecular weight using RAFT polymerization, we studied the copolymerization of butyl acrylate and styrene mediated by 1-phenylethyl phenyl-dithioacetate (PEPDTA) as a RAFT agent. The influences of the type of initiators (AIBN (2-2'-azobis ( isobutyronitrile)), ACC ( 1-1'-azobis ( cyclohexane-carbonitrile)), the concentrations of initiator and polymerization temperature on the copolymerization kinetics and molecular weight and its distribution were investigated. When AIBN was used, the polymerization would stop at middle monomer conversion, which limited the increase of molecular weight of the copolymer if we reduced the initiator concentration. It was found that only with the initiator (ACC) with small decomposition rate constant and high polymerization temperature, the block copolymer with high molecular weight and small fraction of dead chains ( < 0.1) could be synthesized. The reason for these quite strict requirements is that the initiator concentration should remain far below that of the conventional radical polymerization, which is limited by the very low RAFT concentration.

Synthesis of PAN with adjustable molecular weight and low polydispersity index (PDI) value via reverse atom transfer radical polymerization

Study on Kinetics of Controlled/living Radical Polymerization of Acrylonitrile by RAFT Technique

Influence of Small Amount of Co-Monomers on Acrylonitrile Polymerization in Dimethylformamide (DMF) Solution

Studies on the continuous precipitation copolymerization of acrylonitrile in aqueous medium with high monomer feed concentration: I conversion, MW and MWD

Controlled/Living Radical Polymerization of Acrylonitrile: an Overview

Synthesis and Nonisothermal Reaction of A Novel Acrylonitrile-Capped Poly(Propyleneimine) Dendrimer with Epoxy Resin

Preparation of polyacrylonitrile with improved isotacticity and low polydispersity

The Synthesis of High Molecular Weight Block Copolymers by Raft Polymerization

Particle activation/deactivation effect in RAFT emulsion polymerization of styrene

Ab Initio RAFT Emulsion Copolymerization of Styrene and Acrylonitrile

Ab Initio Emulsion RAFT Polymerization of Vinylidene Chloride Mediated by Amphiphilic Macro‐raft Agents

Icar Atrp Of Acrylonitrile Under Ambient And High Pressure

Polymerization-induced Self-Assembly of Acrylonitrile Via ICAR ATRP

A Metal-Free Method for Ultra-High Molecular Weight Polyacrylonitrile under Dimethyl Sulfoxide

Reverse Atom Transfer Radical Polymerization Of Methyl Acrylate Using Aibn As The Initiator Under Heterogeneous Conditions

One-pot and One-step Cu(0)-mediated Reversible-Deactivation Radical Polymerization of N -Isopropylacrylamide (NIPAM) in Water

Controlled Polymerization of Acrylamide via One-Pot and One-Step Aqueous Cu(0)-Mediated Reversible-Deactivation Radical Polymerization

Aqueous Photoiniferter Polymerization of Acrylonitrile

Suppressing the Long‐chain Branching in the Synthesis of Poly(styrene‐b‐butyl Acrylate‐b‐styrene) in RAFT Emulsion Polymerization by Tuning the Interfacial Properties

Graft Polymerization of 2-Hydroxyethyl Methacrylate Via ATRP with Poly(acrylonitrile-Co-p-chloromethyl Styrene) As a Macroinitiator

Linear and comb-like acrylonitrile/<i>N</i>-isopropylacrylamide copolymers synthesized by the combination of RAFT polymerization and ATRP